• Benjamin Herrenschmidt's avatar
    powerpc/xics: Properly set Edge/Level type and enable resend · 880a3d6a
    Benjamin Herrenschmidt authored
    This sets the type of the interrupt appropriately. We set it as follow:
    
     - If not mapped from the device-tree, we use edge. This is the case
    of the virtual interrupts and PCI MSIs for example.
    
     - If mapped from the device-tree and #interrupt-cells is 2 (PAPR
    compliant), we use the second cell to set the appropriate type
    
     - If mapped from the device-tree and #interrupt-cells is 1 (current
    OPAL on P8 does that), we assume level sensitive since those are
    typically going to be the PSI LSIs which are level sensitive.
    
    Additionally, we mark the interrupts requested via the opal_interrupts
    property all level. This is a bit fishy but the best we can do until we
    fix OPAL to properly expose them with a complete descriptor. It is also
    correct for the current HW anyway as OPAL interrupts are currently PCI
    error and PSI interrupts which are level.
    
    Finally now that edge interrupts are properly identified, we can enable
    CONFIG_HARDIRQS_SW_RESEND which will make the core re-send them if
    they occur while masked, which some drivers rely upon.
    
    This fixes issues with lost interrupts on some Mellanox adapters.
    Signed-off-by: default avatarBenjamin Herrenschmidt <benh@kernel.crashing.org>
    Signed-off-by: default avatarMichael Ellerman <mpe@ellerman.id.au>
    880a3d6a
Kconfig 217 Bytes