Sandisk SN530 NVMe drives have broken MSIs. On systems without MSI-X
support, all commands time out resulting in the following message:

nvme nvme0: I/O tag 12 (100c) QID 0 timeout, completion polled

These timeouts cause the boot to take an excessively-long time (over 20
minutes) while the initial command queue is flushed.

Address this by adding a quirk for drives with buggy MSIs. The lspci
output for this device (recorded on a system with MSI-X support) is:

02:00.0 Non-Volatile memory controller: Sandisk Corp Device 5008 (rev 01) (prog-if 02 [NVM Express])
	Subsystem: Sandisk Corp Device 5008
	Flags: bus master, fast devsel, latency 0, IRQ 16, NUMA node 0
	Memory at f7e00000 (64-bit, non-prefetchable) [size=16K]
	Memory at f7e04000 (64-bit, non-prefetchable) [size=256]
	Capabilities: [80] Power Management version 3
	Capabilities: [90] MSI: Enable- Count=1/32 Maskable- 64bit+
	Capabilities: [b0] MSI-X: Enable+ Count=17 Masked-
	Capabilities: [c0] Express Endpoint, MSI 00
	Capabilities: [100] Advanced Error Reporting
	Capabilities: [150] Device Serial Number 00-00-00-00-00-00-00-00
	Capabilities: [1b8] Latency Tolerance Reporting
	Capabilities: [300] Secondary PCI Express
	Capabilities: [900] L1 PM Substates
	Kernel driver in use: nvme
	Kernel modules: nvme

Cc: <stable@vger.kernel.org>
Signed-off-by: Sean Anderson <sean.anderson@linux.dev>
Reviewed-by: Christoph Hellwig <hch@lst.de>