arm64: dts: ti: k3-j7200: Remove PCIe endpoint node

This node is an example node for the PCIe controller in "endpoint" mode.
By default the controller is in "root complex" mode and there is already a
DT node for the same.

Examples should go in the bindings or other documentation.

Remove this node.
Signed-off-by: Andrew Davis <afd@ti.com>
Link: https://lore.kernel.org/r/20240124183659.149119-2-afd@ti.comSigned-off-by: Vignesh Raghavendra <vigneshr@ti.com>

arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts

@@ -388,10 +388,3 @@ &pcie1_rc {
 	phy-names = "pcie-phy";
 	num-lanes = <2>;
 };
-
-&pcie1_ep {
-	phys = <&serdes0_pcie_link>;
-	phy-names = "pcie-phy";
-	num-lanes = <2>;
-	status = "disabled";
-};

arch/arm64/boot/dts/ti/k3-j7200-main.dtsi

@@ -773,26 +773,6 @@ pcie1_rc: pcie@2910000 {
 		status = "disabled";
 	};
 
-	pcie1_ep: pcie-ep@2910000 {
-		compatible = "ti,j7200-pcie-ep", "ti,j721e-pcie-ep";
-		reg = <0x00 0x02910000 0x00 0x1000>,
-		      <0x00 0x02917000 0x00 0x400>,
-		      <0x00 0x0d800000 0x00 0x00800000>,
-		      <0x00 0x18000000 0x00 0x08000000>;
-		reg-names = "intd_cfg", "user_cfg", "reg", "mem";
-		interrupt-names = "link_state";
-		interrupts = <GIC_SPI 330 IRQ_TYPE_EDGE_RISING>;
-		ti,syscon-pcie-ctrl = <&scm_conf 0x4074>;
-		max-link-speed = <3>;
-		num-lanes = <4>;
-		power-domains = <&k3_pds 240 TI_SCI_PD_EXCLUSIVE>;
-		clocks = <&k3_clks 240 6>;
-		clock-names = "fck";
-		max-functions = /bits/ 8 <6>;
-		max-virtual-functions = /bits/ 8 <4 4 4 4 0 0>;
-		dma-coherent;
-	};
-
 	usbss0: cdns-usb@4104000 {
 		compatible = "ti,j721e-usb";
 		reg = <0x00 0x4104000 0x00 0x100>;