USB: Serial: ti_usb_3410_5052.c: remove debug module parameter

Now that all usb-serial modules are only using dev_dbg()
the debug module parameter does not do anything at all, so
remove it to reduce any confusion if someone were to try to
use it.

CC: Johan Hovold <jhovold@gmail.com>
CC: Rusty Russell <rusty@rustcorp.com.au>
CC: Adhir Ramjiawan <adhirramjiawan0@gmail.com>
CC: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/usb/serial/ti_usb_3410_5052.c

@@ -150,7 +150,6 @@ static int ti_download_firmware(struct ti_device *tdev);
 /* Data */
 
 /* module parameters */
-static bool debug;
 static int closing_wait = TI_DEFAULT_CLOSING_WAIT;
 static ushort vendor_3410[TI_EXTRA_VID_PID_COUNT];
 static unsigned int vendor_3410_count;
@@ -288,9 +287,6 @@ MODULE_FIRMWARE("mts_edge.fw");
 MODULE_FIRMWARE("mts_mt9234mu.fw");
 MODULE_FIRMWARE("mts_mt9234zba.fw");
 
-module_param(debug, bool, S_IRUGO | S_IWUSR);
-MODULE_PARM_DESC(debug, "Enable debugging, 0=no, 1=yes");
-
 module_param(closing_wait, int, S_IRUGO | S_IWUSR);
 MODULE_PARM_DESC(closing_wait,
     "Maximum wait for data to drain in close, in .01 secs, default is 4000");