Merge tag 'regulator-fix-v5.3-rc8' of...

Merge tag 'regulator-fix-v5.3-rc8' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/regulator

Pull regulator fixes from Mark Brown:
 "This is obviouly very late, containing three small and simple driver
  specific fixes.

  The main one is the TWL fix, this fixes issues with cpufreq on the
  PMICs used with BeagleBoard generation OMAP SoCs which had been broken
  due to changes in the generic OPP code exposing a bug in the regulator
  driver for these devices causing them to think that OPPs weren't
  supported on the system.

  Sorry about sending this so late, I hadn't registered that the TWL
  issue manifested in cpufreq"

* tag 'regulator-fix-v5.3-rc8' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/regulator:
  regulator: twl: voltage lists for vdd1/2 on twl4030
  regulator: act8945a-regulator: fix ldo register addresses in set_mode hook
  regulator: slg51000: Fix a couple NULL vs IS_ERR() checks

drivers/regulator/act8945a-regulator.c

@@ -169,16 +169,16 @@ static int act8945a_set_mode(struct regulator_dev *rdev, unsigned int mode)
 		reg = ACT8945A_DCDC3_CTRL;
 		break;
 	case ACT8945A_ID_LDO1:
-		reg = ACT8945A_LDO1_SUS;
+		reg = ACT8945A_LDO1_CTRL;
 		break;
 	case ACT8945A_ID_LDO2:
-		reg = ACT8945A_LDO2_SUS;
+		reg = ACT8945A_LDO2_CTRL;
 		break;
 	case ACT8945A_ID_LDO3:
-		reg = ACT8945A_LDO3_SUS;
+		reg = ACT8945A_LDO3_CTRL;
 		break;
 	case ACT8945A_ID_LDO4:
-		reg = ACT8945A_LDO4_SUS;
+		reg = ACT8945A_LDO4_CTRL;
 		break;
 	default:
 		return -EINVAL;

drivers/regulator/slg51000-regulator.c

@@ -205,7 +205,7 @@ static int slg51000_of_parse_cb(struct device_node *np,
 	ena_gpiod = devm_gpiod_get_from_of_node(chip->dev, np,
 						"enable-gpios", 0,
 						gflags, "gpio-en-ldo");
-	if (ena_gpiod) {
+	if (!IS_ERR(ena_gpiod)) {
 		config->ena_gpiod = ena_gpiod;
 		devm_gpiod_unhinge(chip->dev, config->ena_gpiod);
 	}
@@ -459,7 +459,7 @@ static int slg51000_i2c_probe(struct i2c_client *client,
 					       GPIOD_OUT_HIGH
 					       | GPIOD_FLAGS_BIT_NONEXCLUSIVE,
 					       "slg51000-cs");
-	if (cs_gpiod) {
+	if (!IS_ERR(cs_gpiod)) {
 		dev_info(dev, "Found chip selector property\n");
 		chip->cs_gpiod = cs_gpiod;
 	}

drivers/regulator/twl-regulator.c

@@ -359,6 +359,17 @@ static const u16 VINTANA2_VSEL_table[] = {
 	2500, 2750,
 };
 
+/* 600mV to 1450mV in 12.5 mV steps */
+static const struct regulator_linear_range VDD1_ranges[] = {
+	REGULATOR_LINEAR_RANGE(600000, 0, 68, 12500)
+};
+
+/* 600mV to 1450mV in 12.5 mV steps, everything above = 1500mV */
+static const struct regulator_linear_range VDD2_ranges[] = {
+	REGULATOR_LINEAR_RANGE(600000, 0, 68, 12500),
+	REGULATOR_LINEAR_RANGE(1500000, 69, 69, 12500)
+};
+
 static int twl4030ldo_list_voltage(struct regulator_dev *rdev, unsigned index)
 {
 	struct twlreg_info	*info = rdev_get_drvdata(rdev);
@@ -427,6 +438,8 @@ static int twl4030smps_get_voltage(struct regulator_dev *rdev)
 }
 
 static const struct regulator_ops twl4030smps_ops = {
+	.list_voltage   = regulator_list_voltage_linear_range,
+
 	.set_voltage	= twl4030smps_set_voltage,
 	.get_voltage	= twl4030smps_get_voltage,
 };
@@ -466,7 +479,8 @@ static const struct twlreg_info TWL4030_INFO_##label = { \
 		}, \
 	}
 
-#define TWL4030_ADJUSTABLE_SMPS(label, offset, num, turnon_delay, remap_conf) \
+#define TWL4030_ADJUSTABLE_SMPS(label, offset, num, turnon_delay, remap_conf, \
+		n_volt) \
 static const struct twlreg_info TWL4030_INFO_##label = { \
 	.base = offset, \
 	.id = num, \
@@ -479,6 +493,9 @@ static const struct twlreg_info TWL4030_INFO_##label = { \
 		.owner = THIS_MODULE, \
 		.enable_time = turnon_delay, \
 		.of_map_mode = twl4030reg_map_mode, \
+		.n_voltages = n_volt, \
+		.n_linear_ranges = ARRAY_SIZE(label ## _ranges), \
+		.linear_ranges = label ## _ranges, \
 		}, \
 	}
 
@@ -518,8 +535,8 @@ TWL4030_ADJUSTABLE_LDO(VSIM, 0x37, 9, 100, 0x00);
 TWL4030_ADJUSTABLE_LDO(VDAC, 0x3b, 10, 100, 0x08);
 TWL4030_ADJUSTABLE_LDO(VINTANA2, 0x43, 12, 100, 0x08);
 TWL4030_ADJUSTABLE_LDO(VIO, 0x4b, 14, 1000, 0x08);
-TWL4030_ADJUSTABLE_SMPS(VDD1, 0x55, 15, 1000, 0x08);
-TWL4030_ADJUSTABLE_SMPS(VDD2, 0x63, 16, 1000, 0x08);
+TWL4030_ADJUSTABLE_SMPS(VDD1, 0x55, 15, 1000, 0x08, 68);
+TWL4030_ADJUSTABLE_SMPS(VDD2, 0x63, 16, 1000, 0x08, 69);
 /* VUSBCP is managed *only* by the USB subchip */
 TWL4030_FIXED_LDO(VINTANA1, 0x3f, 1500, 11, 100, 0x08);
 TWL4030_FIXED_LDO(VINTDIG, 0x47, 1500, 13, 100, 0x08);