[media] tvp5150: Add video format registers configuration values

The tvp5150 video decoder has two operation modes to configure the video
standard used.

If auto-switch mode is enable, the device can sense the signal and detect which
video standard the device is operating. Also the device can be forced to use a
user defined video standard.

Each operation mode uses a different register and the bitmask values to
represent each standard is different.

So we add video standard constants for both autoswitch and no-autoswitch mode.
Signed-off-by: Javier Martinez Canillas <martinez.javier@gmail.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>

drivers/media/video/tvp5150_reg.h

@@ -45,7 +45,22 @@
 
 /* Reserved 1Fh-27h */
 
-#define TVP5150_VIDEO_STD           0x28 /* Video standard */
+#define VIDEO_STD_MASK			 (0x07 >> 1)
+#define TVP5150_VIDEO_STD                0x28 /* Video standard */
+#define VIDEO_STD_AUTO_SWITCH_BIT	 0x00
+#define VIDEO_STD_NTSC_MJ_BIT		 0x02
+#define VIDEO_STD_PAL_BDGHIN_BIT	 0x04
+#define VIDEO_STD_PAL_M_BIT		 0x06
+#define VIDEO_STD_PAL_COMBINATION_N_BIT	 0x08
+#define VIDEO_STD_NTSC_4_43_BIT		 0x0a
+#define VIDEO_STD_SECAM_BIT		 0x0c
+
+#define VIDEO_STD_NTSC_MJ_BIT_AS                 0x01
+#define VIDEO_STD_PAL_BDGHIN_BIT_AS              0x03
+#define VIDEO_STD_PAL_M_BIT_AS		         0x05
+#define VIDEO_STD_PAL_COMBINATION_N_BIT_AS	 0x07
+#define VIDEO_STD_NTSC_4_43_BIT_AS		 0x09
+#define VIDEO_STD_SECAM_BIT_AS		         0x0b
 
 /* Reserved 29h-2bh */