ASoC: codecs: wsa883x: make use of new mute_unmute_on_trigger flag

In the current setup the PA is left unmuted even when the
Soundwire ports are not started streaming. This can lead to click
and pop sounds during start.
There is a same issue in the reverse order where in the PA is
left unmute even after the data stream is stopped, the time
between data stream stopping and port closing is long enough
to accumulate DC on the line resulting in Click/Pop noise
during end of stream.

making use of new mute_unmute_on_trigger flag is helping a
lot with this Click/Pop issues reported on this Codec
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Tested-by: Johan Hovold <johan+linaro@kernel.org>
Link: https://lore.kernel.org/r/20231027105747.32450-3-srinivas.kandagatla@linaro.orgSigned-off-by: Mark Brown <broonie@kernel.org>

sound/soc/codecs/wsa883x.c

@@ -1203,9 +1203,6 @@ static int wsa883x_spkr_event(struct snd_soc_dapm_widget *w,
 			break;
 		}
 
-		snd_soc_component_write_field(component, WSA883X_DRE_CTL_1,
-					      WSA883X_DRE_GAIN_EN_MASK,
-					      WSA883X_DRE_GAIN_FROM_CSR);
 		if (wsa883x->port_enable[WSA883X_PORT_COMP])
 			snd_soc_component_write_field(component, WSA883X_DRE_CTL_0,
 						      WSA883X_DRE_OFFSET_MASK,
@@ -1218,9 +1215,6 @@ static int wsa883x_spkr_event(struct snd_soc_dapm_widget *w,
 		snd_soc_component_write_field(component, WSA883X_PDM_WD_CTL,
 					      WSA883X_PDM_EN_MASK,
 					      WSA883X_PDM_ENABLE);
-		snd_soc_component_write_field(component, WSA883X_PA_FSM_CTL,
-					      WSA883X_GLOBAL_PA_EN_MASK,
-					      WSA883X_GLOBAL_PA_ENABLE);
 
 		break;
 	case SND_SOC_DAPM_PRE_PMD:
@@ -1346,6 +1340,7 @@ static const struct snd_soc_dai_ops wsa883x_dai_ops = {
 	.hw_free = wsa883x_hw_free,
 	.mute_stream = wsa883x_digital_mute,
 	.set_stream = wsa883x_set_sdw_stream,
+	.mute_unmute_on_trigger = true,
 };
 
 static struct snd_soc_dai_driver wsa883x_dais[] = {