libata-core: Allow longer timeout for drive spinup from PUIS

When spinning up a drive from powered on standby mode (PUIS),
SETFEATURES_SPINUP is executed with the default timeout used
for any SETFEATURES subcommand, that is 5+10 seconds. The
total 15s is too short for some drives to complete spinup
(e.g. drives with a large indirection table stored on media),
resulting in ata_dev_read_id to fail twice on the execution
of SETFEATURES_SPINUP. For this feature, allow a larger
default timeout of 30 seconds. However, in the same spirit
as with the timeout of other feature subcommands, do not
ignore ata_probe_timeout if it is set).
Signed-off-by: Damien Le Moal <damien.lemoal@hgst.com>
Signed-off-by: Tejun Heo <tj@kernel.org>

drivers/ata/libata-core.c

@@ -4528,6 +4528,7 @@ unsigned int ata_dev_set_feature(struct ata_device *dev, u8 enable, u8 feature)
 {
 	struct ata_taskfile tf;
 	unsigned int err_mask;
+	unsigned long timeout = 0;
 
 	/* set up set-features taskfile */
 	DPRINTK("set features - SATA features\n");
@@ -4539,7 +4540,10 @@ unsigned int ata_dev_set_feature(struct ata_device *dev, u8 enable, u8 feature)
 	tf.protocol = ATA_PROT_NODATA;
 	tf.nsect = feature;
 
-	err_mask = ata_exec_internal(dev, &tf, NULL, DMA_NONE, NULL, 0, 0);
+	if (enable == SETFEATURES_SPINUP)
+		timeout = ata_probe_timeout ?
+			  ata_probe_timeout * 1000 : SETFEATURES_SPINUP_TIMEOUT;
+	err_mask = ata_exec_internal(dev, &tf, NULL, DMA_NONE, NULL, 0, timeout);
 
 	DPRINTK("EXIT, err_mask=%x\n", err_mask);
 	return err_mask;

include/linux/ata.h

@@ -371,7 +371,8 @@ enum {
 	SETFEATURES_AAM_ON	= 0x42,
 	SETFEATURES_AAM_OFF	= 0xC2,
 
-	SETFEATURES_SPINUP	= 0x07, /* Spin-up drive */
+	SETFEATURES_SPINUP		= 0x07, /* Spin-up drive */
+	SETFEATURES_SPINUP_TIMEOUT	= 30000, /* 30s timeout for drive spin-up from PUIS */
 
 	SETFEATURES_SATA_ENABLE = 0x10, /* Enable use of SATA feature */
 	SETFEATURES_SATA_DISABLE = 0x90, /* Disable use of SATA feature */