iommu/mediatek: Support up to 34bit iova in tlb flush

If the iova is 34bit, the iova[32][33] is the bit0/1 in the tlb flush
register. Add a new macro for this.

In the macro, since (iova + size - 1) may be end with 0xfff, then the
bit0/1 always is 1, thus add a mask.
Signed-off-by: Yong Wu <yong.wu@mediatek.com>
Reviewed-by: Tomasz Figa <tfiga@chromium.org>
Link: https://lore.kernel.org/r/20210111111914.22211-22-yong.wu@mediatek.comSigned-off-by: Will Deacon <will@kernel.org>

drivers/iommu/mtk_iommu.c

@@ -129,6 +129,11 @@ static const struct iommu_ops mtk_iommu_ops;
 
 static int mtk_iommu_hw_init(const struct mtk_iommu_data *data);
 
+#define MTK_IOMMU_TLB_ADDR(iova) ({					\
+	dma_addr_t _addr = iova;					\
+	((lower_32_bits(_addr) & GENMASK(31, 12)) | upper_32_bits(_addr));\
+})
+
 /*
  * In M4U 4GB mode, the physical address is remapped as below:
  *
@@ -213,8 +218,9 @@ static void mtk_iommu_tlb_flush_range_sync(unsigned long iova, size_t size,
 		writel_relaxed(F_INVLD_EN1 | F_INVLD_EN0,
 			       data->base + data->plat_data->inv_sel_reg);
 
-		writel_relaxed(iova, data->base + REG_MMU_INVLD_START_A);
-		writel_relaxed(iova + size - 1,
+		writel_relaxed(MTK_IOMMU_TLB_ADDR(iova),
+			       data->base + REG_MMU_INVLD_START_A);
+		writel_relaxed(MTK_IOMMU_TLB_ADDR(iova + size - 1),
 			       data->base + REG_MMU_INVLD_END_A);
 		writel_relaxed(F_MMU_INV_RANGE,
 			       data->base + REG_MMU_INVALIDATE);