powerpc/powernv/pseries: Rework device adding to IOMMU groups
The powernv platform registers IOMMU groups and adds devices to them from the pci_controller_ops::setup_bridge() hook except one case when virtual functions (SRIOV VFs) are added from a bus notifier. The pseries platform registers IOMMU groups from the pci_controller_ops::dma_bus_setup() hook and adds devices from the pci_controller_ops::dma_dev_setup() hook. The very same bus notifier used for powernv does not add devices for pseries though as __of_scan_bus() adds devices first, then it does the bus/dev DMA setup. Both platforms use iommu_add_device() which takes a device and expects it to have a valid IOMMU table struct with an iommu_table_group pointer which in turn points the iommu_group struct (which represents an IOMMU group). Although the helper seems easy to use, it relies on some pre-existing device configuration and associated data structures which it does not really need. This simplifies iommu_add_device() to take the table_group pointer directly. Pseries already has a table_group pointer handy and the bus notified is not used anyway. For powernv, this copies the existing bus notifier, makes it work for powernv only which means an easy way of getting to the table_group pointer. This was tested on VFs but should also support physical PCI hotplug. Since iommu_add_device() receives the table_group pointer directly, pseries does not do TCE cache invalidation (the hypervisor does) nor allow multiple groups per a VFIO container (in other words sharing an IOMMU table between partitionable endpoints), this removes iommu_table_group_link from pseries. Signed-off-by: Alexey Kardashevskiy <aik@ozlabs.ru> Reviewed-by: David Gibson <david@gibson.dropbear.id.au> Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>
Showing