- 17 Jun, 2021 10 commits
-
-
Felix Fietkau authored
Instead of attaching the last reported rate to tx packets, use ieee80211_tx_status_ext to immediately pass the rate to mac80211 after receiving it from the firmware. Preparation for implementing full tx status reporting Signed-off-by:Felix Fietkau <nbd@nbd.name>
-
Felix Fietkau authored
Fixes AQL issues on full queues, especially with 802.3 encap offload Signed-off-by: -
Felix Fietkau authored
Use ieee80211_tx_status_ext instead of ieee80211_free_skb and ieee80211_tx_status. This makes it compatible with 802.3 encap offload and improves performance by removing a redundant sta lookup Signed-off-by: -
Felix Fietkau authored
Avoid accidentally mapping them to WCID 0 on completion Signed-off-by: -
Felix Fietkau authored
It overwrites mt76_tx_cb data in the skb Signed-off-by: -
Felix Fietkau authored
It overwrites mt76_tx_cb data in the skb Signed-off-by: -
Felix Fietkau authored
Rely on the txs fixed-rate bit instead of info->control.rates Signed-off-by: -
Felix Fietkau authored
It is not really DMA specific, and moving it makes it possible to make some functions in mac.c static Signed-off-by: -
Felix Fietkau authored
The same is done on the other chips already, so it is very likely needed on MT7915 as well Signed-off-by: -
Felix Fietkau authored
Move IRQ processing to a tasklet, similar to MT7615/MT7663 Signed-off-by:
-
- 16 Jun, 2021 30 commits
-
-
David S. Miller authored
Merge tag 'wireless-drivers-next-2021-06-16' of git://git.kernel.org/pub/scm/linux/kernel/git/kvalo/wireless-drivers-next Kalle Valo says: ==================== wireless-drivers-next patches for v5.14 First set of patches for v5.14. Major new features are here support WCN6855 PCI in ath11k and WoWLAN support for wcn36xx. Also smaller fixes and cleanups all over. ath9k * provide STBC info in the received frames brcmfmac * fix setting of station info chains bitmask * correctly report average RSSI in station info rsi * support for changing beacon interval in AP mode ath11k * support for WCN6855 PCI hardware wcn36xx * WoWLAN support with magic packets and GTK rekeying ==================== Signed-off-by:
David S. Miller <davem@davemloft.net>
-
David S. Miller authored
Vadym Kochan says: ==================== Marvell Prestera add flower and match all support Add ACL infrastructure for Prestera Switch ASICs family devices to offload cls_flower rules to be processed in the HW. ACL implementation is based on tc filter api. The flower classifier is supported to configure ACL rules/matches/action. Supported actions: - drop - trap - pass Supported dissector keys: - indev - src_mac - dst_mac - src_ip - dst_ip - ip_proto - src_port - dst_port - vlan_id - vlan_ethtype - icmp type/code - Introduce matchall filter support - Add SPAN API to configure port mirroring. - Add tc mirror action. At this moment, only mirror (egress) action is supported. Example: tc filter ... action mirred egress mirror dev DEV v2: Fixed "newline at EOF warnings" from "git am" by re-applying with --whitespace=fix patch #1: 1) Set TC HW Offload always enabled without disable it [suggested by Vladimir Oltean] by user. It reduced the logic by removing feature handling and acl block disable counting. patch #2: 1) Removed extra not needed diff with prestera_port and [suggested by Vladimir Oltean] prestera_switch lines exchanging in prestera_acl.h 2) Fix local variables ordering to reverse chrostmas tree [suggested by Vladimir Oltean] 3) Use tc_cls_can_offload_and_chain0() in [suggested by Vladimir Oltean] prestera_span_replace() 4) Removed TODO about prio check [suggested by Vladimir Oltean] 5) Rephrase error message if prestera_netdev_check() [suggested by Vladimir Oltean] fails in prestera_span_replace() ==================== Signed-off-by: -
Serhiy Boiko authored
- Introduce matchall filter support - Add SPAN API to configure port mirroring. - Add tc mirror action. At this moment, only mirror (egress) action is supported. Example: tc filter ... action mirred egress mirror dev DEV Co-developed-by:Volodymyr Mytnyk <vmytnyk@marvell.com> Signed-off-by:
Serhiy Boiko <serhiy.boiko@plvision.eu> Signed-off-by:
Vadym Kochan <vkochan@marvell.com> Signed-off-by:
-
Serhiy Boiko authored
Add ACL infrastructure for Prestera Switch ASICs family devices to offload cls_flower rules to be processed in the HW. ACL implementation is based on tc filter api. The flower classifier is supported to configure ACL rules/matches/action. Supported actions: - drop - trap - pass Supported dissector keys: - indev - src_mac - dst_mac - src_ip - dst_ip - ip_proto - src_port - dst_port - vlan_id - vlan_ethtype - icmp type/code Co-developed-by: -
David S. Miller authored
Karsten Graul says: ==================== net/smc: Add SMC statistic support Please apply the following patch series for smc to netdev's net-next tree. This v2 is a resend of the code contained in v1 but with an updated cover letter to describe why we have chosen to use the generic netlink mechanism to access the smc protocol's statistic data. The patchset adds statistic support to the SMC protocol. Per-cpu variables are used to collect the statistic information for better performance and for reducing concurrency pitfalls. The code that is collecting statistic data is implemented in macros to increase code reuse and readability. The generic netlink mechanism in SMC is extended to provide the collected statistics to userspace. Network namespace awareness is also part of the statistics implementation. SMC is a protocol interacting with PCI devices (like RoCE Cards) and runs on top of the TCP protocol. As SMC is a network protocol and not an ethernet device driver, we decided to use the generic netlink interface. This should be comparable to what other protocols in the net subsystem like tipc, ncsi, ieee802154 or tcp, et al, do. There is already an established internal generic netlink interface mechanism in SMC which is used to collect SMC Protocol internal information. This patchset extends that existing mechanism. ==================== Signed-off-by: -
Guvenc Gulce authored
Make the gathered SMC statistics network namespace aware, for each namespace collect an own set of statistic information. Signed-off-by:
Guvenc Gulce <guvenc@linux.ibm.com> Signed-off-by:
Karsten Graul <kgraul@linux.ibm.com> Signed-off-by:
-
Guvenc Gulce authored
Add support to collect more detailed SMC fallback reason statistics and provide these statistics to user space on the netlink interface. Signed-off-by:
-
Guvenc Gulce authored
Add the netlink function which collects the statistics information and delivers it to the userspace. Signed-off-by:
-
Guvenc Gulce authored
Add the ability to collect SMC statistics information. Per-cpu variables are used to collect the statistic information for better performance and for reducing concurrency pitfalls. The code that is collecting statistic data is implemented in macros to increase code reuse and readability. Signed-off-by:
-
Colin Ian King authored
The continue statement at the end of a for-loop has no effect, remove it. Addresses-Coverity: ("Continue has no effect") Signed-off-by:Colin Ian King <colin.king@canonical.com> Reviewed-by:
Ido Schimmel <idosch@nvidia.com> Signed-off-by:
-
David S. Miller authored
Simon Horman says: ==================== Next set of conntrack patches for the nfp driver Louis Peens says: This follows on from the previous series of a similar nature. Looking at the diagram as explained in the previous series this implements changes up to the point where the merged nft entries are saved. There are still bits of stubbed out code where offloading of the flows will be implemented. +-------------+ +----------+ | pre_ct flow +--------+ | nft flow | +-------------+ v +------+---+ +----------+ | | tc_merge +--------+ | +----------+ v v +--------------+ ^ +-------------+ | post_ct flow +-------+ +---+nft_tc merge | +--------------+ | +-------------+ | | | v Offload to nfp ==================== Signed-off-by: -
Louis Peens authored
Fill in code stub to check that the flow actions are valid for merge. The actions of the flow X should not conflict with the matches of flow X+1. For now this check is quite strict and set_actions are very limited, will need to update this when NAT support is added. Signed-off-by:
Louis Peens <louis.peens@corigine.com> Signed-off-by:
Yinjun Zhang <yinjun.zhang@corigine.com> Signed-off-by:
Simon Horman <simon.horman@corigine.com> Signed-off-by:
-
Louis Peens authored
Fill in check_meta stub to check that ct_metadata action fields in the nft flow matches the ct_match data of the post_ct flow. Signed-off-by:
-
Louis Peens authored
Replace merge check stub code with the actual implementation. This checks that the match parts of two tc flows does not conflict. Only overlapping keys needs to be checked, and only the narrowest masked parts needs to be checked, so each key is masked with the AND'd result of both masks before comparing. Signed-off-by:
-
Louis Peens authored
Add in the code to merge the tc_merge objects with the flows received from nft. At the moment flows are just merged blindly as the validity check functions are stubbed out, this will be populated in follow-up patches. Signed-off-by:
-
Louis Peens authored
Add table and struct to save the result of the three-way merge between pre_ct,post_ct, and nft flows. Merging code is to be added in follow-up patches. Signed-off-by:
-
Yinjun Zhang authored
The nft flow will be destroyed after offload cb returns. This means we need save a full copy of it since it can be referenced through other paths other than just the offload cb, for example when a new pre_ct or post_ct entry is added, and it needs to be merged with an existing nft entry. Signed-off-by:
-
Louis Peens authored
Implement code to add and remove nft flows to the relevant list. Registering and deregistering the callback function for the nft table is quite complicated. The safest is to delete the callback on the removal of the last pre_ct flow. This is because if this is also the latest pre_ct flow in software it means that this specific nft table will be freed, so there will not be a later opportunity to do this. Another place where it looks possible to delete the callback is when the last nft_flow is deleted, but this happens under the flow_table lock, which is also taken when deregistering the callback, leading to a deadlock situation. This means the final solution here is to delete the callback when removing the last pre_ct flow, and then clean up any remaining nft_flow entries which may still be present, since there will never be a callback now to do this, leaving them orphaned if not cleaned up here as well. Signed-off-by:
-
Louis Peens authored
Add register/unregister of the nft callback. For now just add stub code to accept the flows, but don't do anything with it. Decided to accept the flows since netfilter will keep on trying to offload a flow if it was rejected, which is quite noisy. Follow-up patches will start implementing the functions to add nft flows to the relevant tables. Signed-off-by:
-
Louis Peens authored
Add functions to handle delete flow callbacks for ct flows. Also accept the flows for offloading by returning 0 instead of -EOPNOTSUPP. Flows will still not actually be offloaded to hw, but at this point it's difficult to not accept the flows and also exercise the cleanup paths properly. Traffic will still be handled safely through the fallback path. Signed-off-by:
-
David S. Miller authored
Weihang Li says: ==================== net: phy: fix some coding-style issues Make some cleanups according to the coding style of kernel. Changes since v1: - Update commit description of #1 and #3. - Avoid changing the indentation in #2. - Change a group of if-else statement into switch from #4 and put it into a single patch. - Put '|' at the end of line in #5 and #7. - Avoid deleting spaces in definition of 'settings' in #5. - Drop #8 from the series which needs more discussion with David. ==================== Signed-off-by: -
Weihang Li authored
Switch statement is clearer than a group of 'if-else'. Signed-off-by:
Weihang Li <liweihang@huawei.com> Reviewed-by:
Andrew Lunn <andrew@lunn.ch> Signed-off-by:
-
Wenpeng Liang authored
Avoid unnecessary line continuations, and put '|' at the end of line. Signed-off-by:
Wenpeng Liang <liangwenpeng@huawei.com> Signed-off-by:
-
Wenpeng Liang authored
It's better to use __func__ than a fixed string to print a function's name. Signed-off-by:
-
Wenpeng Liang authored
Fix following format issues: 1. open brace '{' following function definitions should go to the next line. 2. braces {} are not necessary for single line statements. 3. else should follow close brace '}'. Signed-off-by: -
Wenpeng Liang authored
There are some space related issues, including spaces at the start of the line, before tabs, after open parenthesis and before close parenthesis. Signed-off-by:
-
Wenpeng Liang authored
There are some repeated words in some comments, they should be deleted. Signed-off-by:
-
Wenpeng Liang authored
Block comments should not use a trailing */ on a separate line and every line of a block comment should start with an '*'. Signed-off-by:
-
Wenpeng Liang authored
Add a blank line after declarations, change the order of them and put the assignments and declarations together. Cc: Richard Cochran <richardcochran@gmail.com> Signed-off-by:
-
Subash Abhinov Kasiviswanathan authored
Remove the explicit casts in the checksum complement functions and pass the actual protocol specific headers instead. Signed-off-by:
Subash Abhinov Kasiviswanathan <subashab@codeaurora.org> Signed-off-by:
-
