Commit 3da1ac29 authored by Juliusz Chroboczek's avatar Juliusz Chroboczek

Update README.

parent 91e69d82
......@@ -28,6 +28,12 @@ the Babel netowk, just list them all:
# babel $IPv6 eth0 eth1 sit1
If your node has multiple addresses and you want all of them to
participate in the routing protocol, inject the other addresses as
zero-cost external routes:
# babel -X $IPv6-2 0 -X $IPv6-3 0 $IPv6 eth1
On an access point, you'll probably want to inject external routes
into the Babel network. First check that you have a default route
on your access point:
......@@ -37,6 +43,11 @@ on your access point:
Then run the routing daemon as so:
# babel -n default 256 $IPv6 eth1
# babel -x default 256 $IPv6 eth1
If you find all of this too complicated and error-prone (as I do), you
may want to consider autoconfiguring your routing domain using AHCP:
http://www.pps.jussieu.fr/~jch/software/ahcp/
Juliusz
Juliusz Chroboczek
Markdown is supported
0% or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment