mmc: sdhci: only set 200mA support for 1.8v if 200mA is available

max_current_caps can return 0 if not available from the sd controller.
If no regulator is present or the regulator specifies a current
less then 200ma, we no longer still set the 200mA caps bit anyway.
Signed-off-by: Philip Rakity <prakity@marvell.com>
Reviewed-by: Aaron Lu <aaron_lu@amd.com>
Signed-off-by: Chris Ball <cjb@laptop.org>

drivers/mmc/core/sd.c

@@ -553,13 +553,13 @@ static int sd_set_bus_speed_mode(struct mmc_card *card, u8 *status)
 
 static int sd_set_current_limit(struct mmc_card *card, u8 *status)
 {
-	int current_limit = 0;
+	int current_limit = SD_SET_CURRENT_NO_CHANGE;
 	int err;
 
 	/*
 	 * Current limit switch is only defined for SDR50, SDR104, and DDR50
-	 * bus speed modes. For other bus speed modes, we set the default
-	 * current limit of 200mA.
+	 * bus speed modes. For other bus speed modes, we do not change the
+	 * current limit.
 	 */
 	if ((card->sd_bus_speed == UHS_SDR50_BUS_SPEED) ||
 	    (card->sd_bus_speed == UHS_SDR104_BUS_SPEED) ||
@@ -595,9 +595,9 @@ static int sd_set_current_limit(struct mmc_card *card, u8 *status)
 			if (card->sw_caps.sd3_curr_limit & SD_MAX_CURRENT_200)
 				current_limit = SD_SET_CURRENT_LIMIT_200;
 		}
-	} else
-		current_limit = SD_SET_CURRENT_LIMIT_200;
+	}
 
+	if (current_limit != SD_SET_CURRENT_NO_CHANGE) {
 		err = mmc_sd_switch(card, 1, 3, current_limit, status);
 		if (err)
 			return err;
@@ -606,6 +606,7 @@ static int sd_set_current_limit(struct mmc_card *card, u8 *status)
 			pr_warning("%s: Problem setting current limit!\n",
 				mmc_hostname(card->host));
 
+	}
 	return 0;
 }
 

drivers/mmc/host/sdhci.c

@@ -2914,7 +2914,7 @@ int sdhci_add_host(struct sdhci_host *host)
 			mmc->caps |= MMC_CAP_MAX_CURRENT_600;
 		else if (max_current_180 >= 400)
 			mmc->caps |= MMC_CAP_MAX_CURRENT_400;
-		else
+		else if (max_current_180 >= 200)
 			mmc->caps |= MMC_CAP_MAX_CURRENT_200;
 	}
 

include/linux/mmc/card.h

@@ -149,6 +149,7 @@ struct sd_switch_caps {
 #define SD_SET_CURRENT_LIMIT_400	1
 #define SD_SET_CURRENT_LIMIT_600	2
 #define SD_SET_CURRENT_LIMIT_800	3
+#define SD_SET_CURRENT_NO_CHANGE	(-1)
 
 #define SD_MAX_CURRENT_200	(1 << SD_SET_CURRENT_LIMIT_200)
 #define SD_MAX_CURRENT_400	(1 << SD_SET_CURRENT_LIMIT_400)