xhci: Avoid global symbol pollution with handshake.

Non-static xHCI driver symbols should start with the "xhci_" prefix, in
order to avoid namespace pollution.  Rename the "handshake" function to
"xhci_handshake".
Signed-off-by: Sarah Sharp <sarah.a.sharp@linux.intel.com>
Reported-by: Ben Hutchings <ben@decadent.org.uk>

drivers/usb/host/xhci-ring.c

@@ -318,7 +318,7 @@ static int xhci_abort_cmd_ring(struct xhci_hcd *xhci)
 	 * seconds), then it should assume that the there are
 	 * larger problems with the xHC and assert HCRST.
 	 */
-	ret = handshake(xhci, &xhci->op_regs->cmd_ring,
+	ret = xhci_handshake(xhci, &xhci->op_regs->cmd_ring,
 			CMD_RING_RUNNING, 0, 5 * 1000 * 1000);
 	if (ret < 0) {
 		xhci_err(xhci, "Stopped the command ring failed, "

drivers/usb/host/xhci.c

@@ -40,7 +40,7 @@ MODULE_PARM_DESC(link_quirk, "Don't clear the chain bit on a link TRB");
 
 /* TODO: copied from ehci-hcd.c - can this be refactored? */
 /*
- * handshake - spin reading hc until handshake completes or fails
+ * xhci_handshake - spin reading hc until handshake completes or fails
  * @ptr: address of hc register to be read
  * @mask: bits to look at in result of read
  * @done: value of those bits when handshake succeeds
@@ -52,7 +52,7 @@ MODULE_PARM_DESC(link_quirk, "Don't clear the chain bit on a link TRB");
  * handshake done).  There are two failure modes:  "usec" have passed (major
  * hardware flakeout), or the register reads as all-ones (hardware removed).
  */
-int handshake(struct xhci_hcd *xhci, void __iomem *ptr,
+int xhci_handshake(struct xhci_hcd *xhci, void __iomem *ptr,
 		      u32 mask, u32 done, int usec)
 {
 	u32	result;
@@ -103,7 +103,7 @@ int xhci_halt(struct xhci_hcd *xhci)
 	xhci_dbg(xhci, "// Halt the HC\n");
 	xhci_quiesce(xhci);
 
-	ret = handshake(xhci, &xhci->op_regs->status,
+	ret = xhci_handshake(xhci, &xhci->op_regs->status,
 			STS_HALT, STS_HALT, XHCI_MAX_HALT_USEC);
 	if (!ret) {
 		xhci->xhc_state |= XHCI_STATE_HALTED;
@@ -132,7 +132,7 @@ static int xhci_start(struct xhci_hcd *xhci)
 	 * Wait for the HCHalted Status bit to be 0 to indicate the host is
 	 * running.
 	 */
-	ret = handshake(xhci, &xhci->op_regs->status,
+	ret = xhci_handshake(xhci, &xhci->op_regs->status,
 			STS_HALT, 0, XHCI_MAX_HALT_USEC);
 	if (ret == -ETIMEDOUT)
 		xhci_err(xhci, "Host took too long to start, "
@@ -167,7 +167,7 @@ int xhci_reset(struct xhci_hcd *xhci)
 	command |= CMD_RESET;
 	xhci_writel(xhci, command, &xhci->op_regs->command);
 
-	ret = handshake(xhci, &xhci->op_regs->command,
+	ret = xhci_handshake(xhci, &xhci->op_regs->command,
 			CMD_RESET, 0, 10 * 1000 * 1000);
 	if (ret)
 		return ret;
@@ -177,7 +177,7 @@ int xhci_reset(struct xhci_hcd *xhci)
 	 * xHCI cannot write to any doorbells or operational registers other
 	 * than status until the "Controller Not Ready" flag is cleared.
 	 */
-	ret = handshake(xhci, &xhci->op_regs->status,
+	ret = xhci_handshake(xhci, &xhci->op_regs->status,
 			STS_CNR, 0, 10 * 1000 * 1000);
 
 	for (i = 0; i < 2; ++i) {
@@ -890,7 +890,7 @@ int xhci_suspend(struct xhci_hcd *xhci)
 	command = xhci_readl(xhci, &xhci->op_regs->command);
 	command &= ~CMD_RUN;
 	xhci_writel(xhci, command, &xhci->op_regs->command);
-	if (handshake(xhci, &xhci->op_regs->status,
+	if (xhci_handshake(xhci, &xhci->op_regs->status,
 		      STS_HALT, STS_HALT, XHCI_MAX_HALT_USEC)) {
 		xhci_warn(xhci, "WARN: xHC CMD_RUN timeout\n");
 		spin_unlock_irq(&xhci->lock);
@@ -905,7 +905,8 @@ int xhci_suspend(struct xhci_hcd *xhci)
 	command = xhci_readl(xhci, &xhci->op_regs->command);
 	command |= CMD_CSS;
 	xhci_writel(xhci, command, &xhci->op_regs->command);
-	if (handshake(xhci, &xhci->op_regs->status, STS_SAVE, 0, 10 * 1000)) {
+	if (xhci_handshake(xhci, &xhci->op_regs->status,
+				STS_SAVE, 0, 10 * 1000)) {
 		xhci_warn(xhci, "WARN: xHC save state timeout\n");
 		spin_unlock_irq(&xhci->lock);
 		return -ETIMEDOUT;
@@ -967,7 +968,7 @@ int xhci_resume(struct xhci_hcd *xhci, bool hibernated)
 		command = xhci_readl(xhci, &xhci->op_regs->command);
 		command |= CMD_CRS;
 		xhci_writel(xhci, command, &xhci->op_regs->command);
-		if (handshake(xhci, &xhci->op_regs->status,
+		if (xhci_handshake(xhci, &xhci->op_regs->status,
 			      STS_RESTORE, 0, 10 * 1000)) {
 			xhci_warn(xhci, "WARN: xHC restore state timeout\n");
 			spin_unlock_irq(&xhci->lock);
@@ -1035,7 +1036,7 @@ int xhci_resume(struct xhci_hcd *xhci, bool hibernated)
 	command = xhci_readl(xhci, &xhci->op_regs->command);
 	command |= CMD_RUN;
 	xhci_writel(xhci, command, &xhci->op_regs->command);
-	handshake(xhci, &xhci->op_regs->status, STS_HALT,
+	xhci_handshake(xhci, &xhci->op_regs->status, STS_HALT,
 		  0, 250 * 1000);
 
 	/* step 5: walk topology and initialize portsc,
@@ -3874,7 +3875,8 @@ static int xhci_usb2_software_lpm_test(struct usb_hcd *hcd,
 	spin_lock_irqsave(&xhci->lock, flags);
 
 	/* Check L1 Status */
-	ret = handshake(xhci, pm_addr, PORT_L1S_MASK, PORT_L1S_SUCCESS, 125);
+	ret = xhci_handshake(xhci, pm_addr,
+			PORT_L1S_MASK, PORT_L1S_SUCCESS, 125);
 	if (ret != -ETIMEDOUT) {
 		/* enter L1 successfully */
 		temp = xhci_readl(xhci, addr);

drivers/usb/host/xhci.h

@@ -1720,7 +1720,7 @@ static inline void xhci_unregister_plat(void)
 
 /* xHCI host controller glue */
 typedef void (*xhci_get_quirks_t)(struct device *, struct xhci_hcd *);
-int handshake(struct xhci_hcd *xhci, void __iomem *ptr,
+int xhci_handshake(struct xhci_hcd *xhci, void __iomem *ptr,
 		u32 mask, u32 done, int usec);
 void xhci_quiesce(struct xhci_hcd *xhci);
 int xhci_halt(struct xhci_hcd *xhci);