drm/nv20: Use the nv30 CRTC bandwidth calculation code.

nv2x CRTC FIFOs are as large as in nv3x (4kB it seems), and the FIFO
control registers have the same layout: we can make them share the
same implementation.

Previously we were using the nv1x code, but the calculated FIFO
watermarks are usually too low for nv2x and they cause horrible
scanout artifacts. They've gone unnoticed until now because we've been
leaving one of the bandwidth regs uninitialized (CRE 47, which
contains the most significant bits of FFLWM), so everything seemed to
work fine except in some cases after a cold boot, depending on the
memory bandwidth and pixel clocks used.
Signed-off-by: Francisco Jerez <currojerez@riseup.net>
Signed-off-by: Ben Skeggs <bskeggs@redhat.com>

drivers/gpu/drm/nouveau/nouveau_calc.c

@@ -234,7 +234,7 @@ nv04_update_arb(struct drm_device *dev, int VClk, int bpp,
 }
 
 static void
-nv30_update_arb(int *burst, int *lwm)
+nv20_update_arb(int *burst, int *lwm)
 {
 	unsigned int fifo_size, burst_size, graphics_lwm;
 
@@ -251,14 +251,14 @@ nouveau_calc_arb(struct drm_device *dev, int vclk, int bpp, int *burst, int *lwm
 {
 	struct drm_nouveau_private *dev_priv = dev->dev_private;
 
-	if (dev_priv->card_type < NV_30)
+	if (dev_priv->card_type < NV_20)
 		nv04_update_arb(dev, vclk, bpp, burst, lwm);
 	else if ((dev->pci_device & 0xfff0) == 0x0240 /*CHIPSET_C51*/ ||
 		 (dev->pci_device & 0xfff0) == 0x03d0 /*CHIPSET_C512*/) {
 		*burst = 128;
 		*lwm = 0x0480;
 	} else
-		nv30_update_arb(burst, lwm);
+		nv20_update_arb(burst, lwm);
 }
 
 static int

drivers/gpu/drm/nouveau/nouveau_hw.c

@@ -866,10 +866,11 @@ nv_save_state_ext(struct drm_device *dev, int head,
 	rd_cio_state(dev, head, regp, NV_CIO_CRE_FFLWM__INDEX);
 	rd_cio_state(dev, head, regp, NV_CIO_CRE_21);
 
-	if (dev_priv->card_type >= NV_30) {
+	if (dev_priv->card_type >= NV_20)
 		rd_cio_state(dev, head, regp, NV_CIO_CRE_47);
+
+	if (dev_priv->card_type >= NV_30)
 		rd_cio_state(dev, head, regp, 0x9f);
-	}
 
 	rd_cio_state(dev, head, regp, NV_CIO_CRE_49);
 	rd_cio_state(dev, head, regp, NV_CIO_CRE_HCUR_ADDR0_INDEX);
@@ -976,10 +977,11 @@ nv_load_state_ext(struct drm_device *dev, int head,
 	wr_cio_state(dev, head, regp, NV_CIO_CRE_FF_INDEX);
 	wr_cio_state(dev, head, regp, NV_CIO_CRE_FFLWM__INDEX);
 
-	if (dev_priv->card_type >= NV_30) {
+	if (dev_priv->card_type >= NV_20)
 		wr_cio_state(dev, head, regp, NV_CIO_CRE_47);
+
+	if (dev_priv->card_type >= NV_30)
 		wr_cio_state(dev, head, regp, 0x9f);
-	}
 
 	wr_cio_state(dev, head, regp, NV_CIO_CRE_49);
 	wr_cio_state(dev, head, regp, NV_CIO_CRE_HCUR_ADDR0_INDEX);

drivers/gpu/drm/nouveau/nv04_crtc.c

@@ -826,7 +826,7 @@ nv04_crtc_mode_set_base(struct drm_crtc *crtc, int x, int y,
 	crtc_wr_cio_state(crtc, regp, NV_CIO_CRE_FF_INDEX);
 	crtc_wr_cio_state(crtc, regp, NV_CIO_CRE_FFLWM__INDEX);
 
-	if (dev_priv->card_type >= NV_30) {
+	if (dev_priv->card_type >= NV_20) {
 		regp->CRTC[NV_CIO_CRE_47] = arb_lwm >> 8;
 		crtc_wr_cio_state(crtc, regp, NV_CIO_CRE_47);
 	}