From 6f4728c5e5c633b3df618bdec067c80cbb446d3b Mon Sep 17 00:00:00 2001
From: Ben Dooks <ben.dooks@codethink.co.uk>
Date: Mon, 27 Apr 2015 15:19:10 +0200
Subject: [PATCH] ARM: at91/dt: sama5d3 xplained: fill in mmc1 and set it to
disabled
The mmc1 channel is not populated on the SAM5D3 Xplained board, however
it is enabled and therefore the driver is attaching to it.
The node configuration for mmc1 is missing, so add an mmc1 node in the
device tree and set its status to disabled. Also add the vmmc and the
necessary slot configuration if this node were enabled to avoid the following
warnings from the driver:
atmel_mci f8000000.mmc: No vmmc regulator found
atmel_mci f8000000.mmc: No vqmmc regulator found
Signed-off-by: Ben Dooks <ben.dooks@codethink.co.uk>
Signed-off-by: Ludovic Desroches <ludovic.desroches@atmel.com>
Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
---
arch/arm/boot/dts/at91-sama5d3_xplained.dts | 11 +++++++++++
1 file changed, 11 insertions(+)
diff --git a/arch/arm/boot/dts/at91-sama5d3_xplained.dts b/arch/arm/boot/dts/at91-sama5d3_xplained.dts
index 64636974d7dd..df15587bedcc 100644
--- a/arch/arm/boot/dts/at91-sama5d3_xplained.dts
+++ b/arch/arm/boot/dts/at91-sama5d3_xplained.dts
@@ -43,6 +43,17 @@ slot@0 {
};
};
+ mmc1: mmc@f8000000 {
+ vmmc-supply = <&vcc_3v3_reg>;
+ vqmmc-supply = <&vcc_3v3_reg>;
+ status = "disabled";
+ slot@0 {
+ reg = <0>;
+ bus-width = <4>;
+ cd-gpios = <&pioE 1 GPIO_ACTIVE_LOW>;
+ };
+ };
+
spi0: spi@f0004000 {
cs-gpios = <&pioD 13 0>, <0>, <0>, <&pioD 16 0>;
status = "okay";
--
2.30.9