OMAP2/3: Pass irqflags to 8250 driver

Pass irqflags to 8250 driver with platform_data. At least Zoom2 has
IRQF_TRIGGER_RISING requirement for the 8250 GPIO irq.

This patch is dependent on 8250 driver changes getting accepted upstream:
http://git.kernel.org/?p=linux/kernel/git/sfr/linux-next.git;a=commit;h=7053133124d5cdf207c1168c7a0c582a18e12ea7Signed-off-by: Vikram Pandita <vikram.pandita@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

arch/arm/mach-omap2/board-zoom-debugboard.c

@@ -12,6 +12,7 @@
 #include <linux/gpio.h>
 #include <linux/serial_8250.h>
 #include <linux/smsc911x.h>
+#include <linux/interrupt.h>
 
 #include <mach/gpmc.h>
 
@@ -84,6 +85,7 @@ static struct plat_serial8250_port serial_platform_data[] = {
 		.mapbase	= 0x10000000,
 		.irq		= OMAP_GPIO_IRQ(102),
 		.flags		= UPF_BOOT_AUTOCONF|UPF_IOREMAP|UPF_SHARE_IRQ,
+		.irqflags	= IRQF_SHARED | IRQF_TRIGGER_RISING,
 		.iotype		= UPIO_MEM,
 		.regshift	= 1,
 		.uartclk	= QUART_CLK,

arch/arm/mach-omap2/serial.c

@@ -460,7 +460,7 @@ static void omap_uart_idle_init(struct omap_uart_state *uart)
 		uart->padconf = 0;
 	}
 
-	p->flags |= UPF_SHARE_IRQ;
+	p->irqflags |= IRQF_SHARED;
 	ret = request_irq(p->irq, omap_uart_interrupt, IRQF_SHARED,
 			  "serial idle", (void *)uart);
 	WARN_ON(ret);