spi: Fixed division by zero warning

The reason for dividing by zero is because the dummy bus width is zero,
but if the dummy n bytes is zero, it indicates that there is no data transfer,
so there is no need for calculation.

Fixes: 7512eaf5 ("spi: cadence-quadspi: Fix dummy cycle calculation when buswidth > 1")
Signed-off-by: Yoshitaka Ikeda <ikeda@nskint.co.jp>
Acked-by: Pratyush Yadav <p.yadav@ti.com>
Link: https://lore.kernel.org/r/OSZPR01MB70049C8F56ED8902852DF97B8BD49@OSZPR01MB7004.jpnprd01.prod.outlook.comSigned-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/atmel-quadspi.c

@@ -310,7 +310,7 @@ static int atmel_qspi_set_cfg(struct atmel_qspi *aq,
 		return mode;
 	ifr |= atmel_qspi_modes[mode].config;
 
-	if (op->dummy.buswidth && op->dummy.nbytes)
+	if (op->dummy.nbytes)
 		dummy_cycles = op->dummy.nbytes * 8 / op->dummy.buswidth;
 
 	/*

drivers/spi/spi-bcm-qspi.c

@@ -395,6 +395,7 @@ static int bcm_qspi_bspi_set_flex_mode(struct bcm_qspi *qspi,
 	if (addrlen == BSPI_ADDRLEN_4BYTES)
 		bpp = BSPI_BPP_ADDR_SELECT_MASK;
 
+	if (op->dummy.nbytes)
 		bpp |= (op->dummy.nbytes * 8) / op->dummy.buswidth;
 
 	switch (width) {

drivers/spi/spi-mtk-nor.c

@@ -160,7 +160,7 @@ static bool mtk_nor_match_read(const struct spi_mem_op *op)
 {
 	int dummy = 0;
 
-	if (op->dummy.buswidth)
+	if (op->dummy.nbytes)
 		dummy = op->dummy.nbytes * BITS_PER_BYTE / op->dummy.buswidth;
 
 	if ((op->data.buswidth == 2) || (op->data.buswidth == 4)) {

drivers/spi/spi-stm32-qspi.c

@@ -397,7 +397,7 @@ static int stm32_qspi_send(struct spi_mem *mem, const struct spi_mem_op *op)
 		ccr |= FIELD_PREP(CCR_ADSIZE_MASK, op->addr.nbytes - 1);
 	}
 
-	if (op->dummy.buswidth && op->dummy.nbytes)
+	if (op->dummy.nbytes)
 		ccr |= FIELD_PREP(CCR_DCYC_MASK,
 				  op->dummy.nbytes * 8 / op->dummy.buswidth);