Commit 0e7ade47 authored by Mauro Carvalho Chehab's avatar Mauro Carvalho Chehab Committed by Jonathan Corbet

docs: misc-devices/bh1770glc.txt: convert to ReST

- Adjust document title markup;
- use list markups;
- Adjust identations to display properly at ReST output.
Signed-off-by: default avatarMauro Carvalho Chehab <mchehab+huawei@kernel.org>
Link: https://lore.kernel.org/r/58ba712524318d03b3196bba33cb409472b4807d.1592203650.git.mchehab+huawei@kernel.orgSigned-off-by: default avatarJonathan Corbet <corbet@lwn.net>
parent 433b1b0d
.. SPDX-License-Identifier: GPL-2.0
=======================
Kernel driver bh1770glc
=======================
Supported chips:
ROHM BH1770GLC
OSRAM SFH7770
- ROHM BH1770GLC
- OSRAM SFH7770
Data sheet:
Not freely available
......@@ -48,12 +52,16 @@ chip_id
RO - shows detected chip type and version
power_state
RW - enable / disable chip. Uses counting logic
1 enables the chip
0 disables the chip
RW - enable / disable chip
Uses counting logic
- 1 enables the chip
- 0 disables the chip
lux0_input
RO - measured lux value
sysfs_notify called when threshold interrupt occurs
lux0_sensor_range
......@@ -66,16 +74,22 @@ lux0_rate_avail
RO - supported measurement rates
lux0_thresh_above_value
RW - HI level threshold value. All results above the value
RW - HI level threshold value
All results above the value
trigs an interrupt. 65535 (i.e. sensor_range) disables the above
interrupt.
lux0_thresh_below_value
RW - LO level threshold value. All results below the value
RW - LO level threshold value
All results below the value
trigs an interrupt. 0 disables the below interrupt.
lux0_calibscale
RW - calibration value. Set to neutral value by default.
RW - calibration value
Set to neutral value by default.
Output results are multiplied with calibscale / calibscale_default
value.
......@@ -84,15 +98,19 @@ lux0_calibscale_default
prox0_raw
RO - measured proximity value
sysfs_notify called when threshold interrupt occurs
prox0_sensor_range
RO - prox0_raw max value
prox0_raw_en
RW - enable / disable proximity - uses counting logic
1 enables the proximity
0 disables the proximity
RW - enable / disable proximity
Uses counting logic
- 1 enables the proximity
- 0 disables the proximity
prox0_thresh_above_count
RW - number of proximity interrupts needed before triggering the event
......@@ -110,6 +128,7 @@ prox0_rate_avail
prox0_thresh_above0_value
RW - threshold level which trigs proximity events.
Filtered by persistence filter (prox0_thresh_above_count)
prox0_thresh_above1_value
......
......@@ -15,6 +15,7 @@ fit into other categories.
:maxdepth: 2
ad525x_dpot
bh1770glc
eeprom
c2port
ibmvmc
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment