media: staging: rkisp1: isp: check for dphy bus before initializations in s_stream

In rkisp1_isp_s_stream it is better to return error in case the
bus type is not dphy before initializing the registers.
Signed-off-by: Dafna Hirschfeld <dafna.hirschfeld@collabora.com>
Acked-by: Helen Koike <helen.koike@collabora.com>
Acked-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>

drivers/staging/media/rkisp1/rkisp1-isp.c

@@ -947,14 +947,14 @@ static int rkisp1_isp_s_stream(struct v4l2_subdev *sd, int enable)
 	rkisp1->active_sensor = container_of(sensor_sd->asd,
 					     struct rkisp1_sensor_async, asd);
 
+	if (rkisp1->active_sensor->mbus.type != V4L2_MBUS_CSI2_DPHY)
+		return -EINVAL;
+
 	atomic_set(&rkisp1->isp.frame_sequence, -1);
 	ret = rkisp1_config_cif(rkisp1);
 	if (ret)
 		return ret;
 
-	if (rkisp1->active_sensor->mbus.type != V4L2_MBUS_CSI2_DPHY)
-		return -EINVAL;
-
 	ret = rkisp1_mipi_csi2_start(&rkisp1->isp, rkisp1->active_sensor);
 	if (ret)
 		return ret;