drm/lcdif: Do not disable clocks on already suspended hardware

In case the LCDIF is enabled in DT but unused, the clocks used by the
LCDIF are not enabled. Those clocks may even have a use count of 0 in
case there are no other users of those clocks. This can happen e.g. in
case the LCDIF drives HDMI bridge which has no panel plugged into the
HDMI connector.

Do not attempt to disable clocks in the suspend callback and re-enable
clocks in the resume callback unless the LCDIF is enabled and was in
use before the system entered suspend, otherwise the driver might end
up trying to disable clocks which are already disabled with use count
0, and would trigger a warning from clock core about this condition.

Note that the lcdif_rpm_suspend() and lcdif_rpm_resume() functions
internally perform the clocks disable and enable operations and act
as runtime PM hooks too.
Reviewed-by: Liu Ying <victor.liu@nxp.com>
Fixes: 9db35bb3 ("drm: lcdif: Add support for i.MX8MP LCDIF variant")
Signed-off-by: Marek Vasut <marex@denx.de>
Link: https://patchwork.freedesktop.org/patch/msgid/20240226082644.32603-1-marex@denx.de

drivers/gpu/drm/mxsfb/lcdif_drv.c

@@ -343,6 +343,9 @@ static int __maybe_unused lcdif_suspend(struct device *dev)
 	if (ret)
 		return ret;
 
+	if (pm_runtime_suspended(dev))
+		return 0;
+
 	return lcdif_rpm_suspend(dev);
 }
 
@@ -350,6 +353,7 @@ static int __maybe_unused lcdif_resume(struct device *dev)
 {
 	struct drm_device *drm = dev_get_drvdata(dev);
 
+	if (!pm_runtime_suspended(dev))
 		lcdif_rpm_resume(dev);
 
 	return drm_mode_config_helper_resume(drm);