mei: drop ready bits check after start

The check that hardware and host ready bits are set after start
is redundant and may fail and disable driver if there is
back-to-back link reset issued right after start.
This happens during pxp mode transitions when firmware
undergo reset. Remove these checks to eliminate such failures.
Signed-off-by: Alexander Usyskin <alexander.usyskin@intel.com>
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Reviewed-by: Daniele Ceraolo Spurio <daniele.ceraolospurio@intel.com>
Signed-off-by: Daniele Ceraolo Spurio <daniele.ceraolospurio@intel.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20220907215113.1596567-14-tomas.winkler@intel.comAcked-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Signed-off-by: Joonas Lahtinen <joonas.lahtinen@linux.intel.com>

drivers/misc/mei/init.c

@@ -218,16 +218,6 @@ int mei_start(struct mei_device *dev)
 		goto err;
 	}
 
-	if (!mei_host_is_ready(dev)) {
-		dev_err(dev->dev, "host is not ready.\n");
-		goto err;
-	}
-
-	if (!mei_hw_is_ready(dev)) {
-		dev_err(dev->dev, "ME is not ready.\n");
-		goto err;
-	}
-
 	if (!mei_hbm_version_is_supported(dev)) {
 		dev_dbg(dev->dev, "MEI start failed.\n");
 		goto err;