Merge branch 'net-ll_temac-x86_64-support'

Esben Haabendal says:

====================
net: ll_temac: x86_64 support

This patch series adds support for use of ll_temac driver with
platform_data configuration and fixes endianess and 64-bit problems so
that it can be used on x86_64 platform.

A few bugfixes are also included.

Changes since v2:
  - Fixed lp->indirect_mutex initialization regression for OF
    platforms introduced in v2

Changes since v1:
  - Make indirect_mutex specification mandatory when using platform_data
  - Move header to include/linux/platform_data
  - Enable COMPILE_TEST for XILINX_LL_TEMAC
  - Rebased to v5.1-rc7
====================
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/xilinx/Kconfig

@@ -5,7 +5,7 @@
 config NET_VENDOR_XILINX
 	bool "Xilinx devices"
 	default y
-	depends on PPC || PPC32 || MICROBLAZE || ARCH_ZYNQ || MIPS
+	depends on PPC || PPC32 || MICROBLAZE || ARCH_ZYNQ || MIPS || X86 || COMPILE_TEST
 	---help---
 	  If you have a network (Ethernet) card belonging to this class, say Y.
 
@@ -33,8 +33,7 @@ config XILINX_AXI_EMAC
 
 config XILINX_LL_TEMAC
 	tristate "Xilinx LL TEMAC (LocalLink Tri-mode Ethernet MAC) driver"
-	depends on (PPC || MICROBLAZE)
-	depends on !64BIT || BROKEN
+	depends on PPC || MICROBLAZE || X86 || COMPILE_TEST
 	select PHYLIB
 	---help---
 	  This driver supports the Xilinx 10/100/1000 LocalLink TEMAC

drivers/net/ethernet/xilinx/ll_temac.h

@@ -334,6 +334,9 @@ struct temac_local {
 
 	/* Connection to PHY device */
 	struct device_node *phy_node;
+	/* For non-device-tree devices */
+	char phy_name[MII_BUS_ID_SIZE + 3];
+	phy_interface_t phy_interface;
 
 	/* MDIO bus data */
 	struct mii_bus *mii_bus;	/* MII bus reference */
@@ -344,8 +347,10 @@ struct temac_local {
 #ifdef CONFIG_PPC_DCR
 	dcr_host_t sdma_dcrs;
 #endif
-	u32 (*dma_in)(struct temac_local *, int);
-	void (*dma_out)(struct temac_local *, int, u32);
+	u32 (*temac_ior)(struct temac_local *lp, int offset);
+	void (*temac_iow)(struct temac_local *lp, int offset, u32 value);
+	u32 (*dma_in)(struct temac_local *lp, int reg);
+	void (*dma_out)(struct temac_local *lp, int reg, u32 value);
 
 	int tx_irq;
 	int rx_irq;
@@ -353,7 +358,10 @@ struct temac_local {
 
 	struct sk_buff **rx_skb;
 	spinlock_t rx_lock;
-	struct mutex indirect_mutex;
+	/* For synchronization of indirect register access.  Must be
+	 * shared mutex between interfaces in same TEMAC block.
+	 */
+	struct mutex *indirect_mutex;
 	u32 options;			/* Current options word */
 	int last_link;
 	unsigned int temac_features;
@@ -367,18 +375,24 @@ struct temac_local {
 	int tx_bd_next;
 	int tx_bd_tail;
 	int rx_bd_ci;
+
+	/* DMA channel control setup */
+	u32 tx_chnl_ctrl;
+	u32 rx_chnl_ctrl;
 };
 
+/* Wrappers for temac_ior()/temac_iow() function pointers above */
+#define temac_ior(lp, o) ((lp)->temac_ior(lp, o))
+#define temac_iow(lp, o, v) ((lp)->temac_iow(lp, o, v))
+
 /* xilinx_temac.c */
-u32 temac_ior(struct temac_local *lp, int offset);
-void temac_iow(struct temac_local *lp, int offset, u32 value);
 int temac_indirect_busywait(struct temac_local *lp);
 u32 temac_indirect_in32(struct temac_local *lp, int reg);
 void temac_indirect_out32(struct temac_local *lp, int reg, u32 value);
 
 
 /* xilinx_temac_mdio.c */
-int temac_mdio_setup(struct temac_local *lp, struct device_node *np);
+int temac_mdio_setup(struct temac_local *lp, struct platform_device *pdev);
 void temac_mdio_teardown(struct temac_local *lp);
 
 #endif /* XILINX_LL_TEMAC_H */

drivers/net/ethernet/xilinx/ll_temac_mdio.c

@@ -14,6 +14,7 @@
 #include <linux/of_address.h>
 #include <linux/slab.h>
 #include <linux/of_mdio.h>
+#include <linux/platform_data/xilinx-ll-temac.h>
 
 #include "ll_temac.h"
 
@@ -28,10 +29,10 @@ static int temac_mdio_read(struct mii_bus *bus, int phy_id, int reg)
 	/* Write the PHY address to the MIIM Access Initiator register.
 	 * When the transfer completes, the PHY register value will appear
 	 * in the LSW0 register */
-	mutex_lock(&lp->indirect_mutex);
+	mutex_lock(lp->indirect_mutex);
 	temac_iow(lp, XTE_LSW0_OFFSET, (phy_id << 5) | reg);
 	rc = temac_indirect_in32(lp, XTE_MIIMAI_OFFSET);
-	mutex_unlock(&lp->indirect_mutex);
+	mutex_unlock(lp->indirect_mutex);
 
 	dev_dbg(lp->dev, "temac_mdio_read(phy_id=%i, reg=%x) == %x\n",
 		phy_id, reg, rc);
@@ -49,25 +50,34 @@ static int temac_mdio_write(struct mii_bus *bus, int phy_id, int reg, u16 val)
 	/* First write the desired value into the write data register
 	 * and then write the address into the access initiator register
 	 */
-	mutex_lock(&lp->indirect_mutex);
+	mutex_lock(lp->indirect_mutex);
 	temac_indirect_out32(lp, XTE_MGTDR_OFFSET, val);
 	temac_indirect_out32(lp, XTE_MIIMAI_OFFSET, (phy_id << 5) | reg);
-	mutex_unlock(&lp->indirect_mutex);
+	mutex_unlock(lp->indirect_mutex);
 
 	return 0;
 }
 
-int temac_mdio_setup(struct temac_local *lp, struct device_node *np)
+int temac_mdio_setup(struct temac_local *lp, struct platform_device *pdev)
 {
+	struct ll_temac_platform_data *pdata = dev_get_platdata(&pdev->dev);
+	struct device_node *np = dev_of_node(&pdev->dev);
 	struct mii_bus *bus;
 	u32 bus_hz;
 	int clk_div;
 	int rc;
 	struct resource res;
 
+	/* Get MDIO bus frequency (if specified) */
+	bus_hz = 0;
+	if (np)
+		of_property_read_u32(np, "clock-frequency", &bus_hz);
+	else if (pdata)
+		bus_hz = pdata->mdio_clk_freq;
+
 	/* Calculate a reasonable divisor for the clock rate */
 	clk_div = 0x3f; /* worst-case default setting */
-	if (of_property_read_u32(np, "clock-frequency", &bus_hz) == 0) {
+	if (bus_hz != 0) {
 		clk_div = bus_hz / (2500 * 1000 * 2) - 1;
 		if (clk_div < 1)
 			clk_div = 1;
@@ -77,17 +87,23 @@ int temac_mdio_setup(struct temac_local *lp, struct device_node *np)
 
 	/* Enable the MDIO bus by asserting the enable bit and writing
 	 * in the clock config */
-	mutex_lock(&lp->indirect_mutex);
+	mutex_lock(lp->indirect_mutex);
 	temac_indirect_out32(lp, XTE_MC_OFFSET, 1 << 6 | clk_div);
-	mutex_unlock(&lp->indirect_mutex);
+	mutex_unlock(lp->indirect_mutex);
 
-	bus = mdiobus_alloc();
+	bus = devm_mdiobus_alloc(&pdev->dev);
 	if (!bus)
 		return -ENOMEM;
 
+	if (np) {
 		of_address_to_resource(np, 0, &res);
 		snprintf(bus->id, MII_BUS_ID_SIZE, "%.8llx",
 			 (unsigned long long)res.start);
+	} else if (pdata && pdata->mdio_bus_id >= 0) {
+		snprintf(bus->id, MII_BUS_ID_SIZE, "%.8llx",
+			 pdata->mdio_bus_id);
+	}
+
 	bus->priv = lp;
 	bus->name = "Xilinx TEMAC MDIO";
 	bus->read = temac_mdio_read;
@@ -98,23 +114,16 @@ int temac_mdio_setup(struct temac_local *lp, struct device_node *np)
 
 	rc = of_mdiobus_register(bus, np);
 	if (rc)
-		goto err_register;
+		return rc;
 
-	mutex_lock(&lp->indirect_mutex);
+	mutex_lock(lp->indirect_mutex);
 	dev_dbg(lp->dev, "MDIO bus registered;  MC:%x\n",
 		temac_indirect_in32(lp, XTE_MC_OFFSET));
-	mutex_unlock(&lp->indirect_mutex);
+	mutex_unlock(lp->indirect_mutex);
 	return 0;
-
- err_register:
-	mdiobus_free(bus);
-	return rc;
 }
 
 void temac_mdio_teardown(struct temac_local *lp)
 {
 	mdiobus_unregister(lp->mii_bus);
-	mdiobus_free(lp->mii_bus);
-	lp->mii_bus = NULL;
 }
-

include/linux/platform_data/xilinx-ll-temac.h

+/* SPDX-License-Identifier: GPL-2.0 */
+#ifndef __LINUX_XILINX_LL_TEMAC_H
+#define __LINUX_XILINX_LL_TEMAC_H
+
+#include <linux/if_ether.h>
+#include <linux/phy.h>
+
+struct ll_temac_platform_data {
+	bool txcsum;		/* Enable/disable TX checksum */
+	bool rxcsum;		/* Enable/disable RX checksum */
+	u8 mac_addr[ETH_ALEN];	/* MAC address (6 bytes) */
+	/* Clock frequency for input to MDIO clock generator */
+	u32 mdio_clk_freq;
+	unsigned long long mdio_bus_id; /* Unique id for MDIO bus */
+	int phy_addr;		/* Address of the PHY to connect to */
+	phy_interface_t phy_interface; /* PHY interface mode */
+	bool reg_little_endian;	/* Little endian TEMAC register access  */
+	bool dma_little_endian;	/* Little endian DMA register access  */
+	/* Pre-initialized mutex to use for synchronizing indirect
+	 * register access.  When using both interfaces of a single
+	 * TEMAC IP block, the same mutex should be passed here, as
+	 * they share the same DCR bus bridge.
+	 */
+	struct mutex *indirect_mutex;
+	/* DMA channel control setup */
+	u8 tx_irq_timeout;	/* TX Interrupt Delay Time-out */
+	u8 tx_irq_count;	/* TX Interrupt Coalescing Threshold Count */
+	u8 rx_irq_timeout;	/* RX Interrupt Delay Time-out */
+	u8 rx_irq_count;	/* RX Interrupt Coalescing Threshold Count */
+};
+
+#endif /* __LINUX_XILINX_LL_TEMAC_H */