ARM: dts: imx6qdl-sr-som: fix some cubox-i platforms

The PHY address bit 2 is configured by the LED pin. Attaching a LED
to this pin is not sufficient to guarantee this configuration pin is
correctly read. This leads to some platforms having their PHY at
address 0 and others at address 4.

If there is no phy-handle specified, the FEC driver will scan the PHY
bus for a PHY and use that. Consequently, adding the DT configuration
of the PHY and the phy properties to the FEC driver broke some boards.

Fix this by removing the phy-handle property, and listing two PHY
entries for both possible PHY addresses, so that the DT configuration
for the PHY can be found by the PHY driver.

Fixes: 86b08bd5 ("ARM: dts: imx6-sr-som: add ethernet PHY configuration")
Reported-by: Christoph Mattheis <christoph.mattheis@arcor.de>
Signed-off-by: Russell King <rmk+kernel@armlinux.org.uk>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

arch/arm/boot/dts/imx6qdl-sr-som.dtsi

@@ -53,7 +53,6 @@ vcc_3v3: regulator-vcc-3v3 {
 &fec {
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_microsom_enet_ar8035>;
-	phy-handle = <&phy>;
 	phy-mode = "rgmii-id";
 	phy-reset-duration = <2>;
 	phy-reset-gpios = <&gpio4 15 GPIO_ACTIVE_LOW>;
@@ -63,10 +62,19 @@ mdio {
 		#address-cells = <1>;
 		#size-cells = <0>;
 
-		phy: ethernet-phy@0 {
+		/*
+		 * The PHY can appear at either address 0 or 4 due to the
+		 * configuration (LED) pin not being pulled sufficiently.
+		 */
+		ethernet-phy@0 {
 			reg = <0>;
 			qca,clk-out-frequency = <125000000>;
 		};
+
+		ethernet-phy@4 {
+			reg = <4>;
+			qca,clk-out-frequency = <125000000>;
+		};
 	};
 };