Commit 34d27853 authored by Mark Brown's avatar Mark Brown Committed by Dmitry Torokhov

Input: wm97xx-core - support use as a wakeup source

The WM97xx touch screen controllers can be used to generate a wakeup
event when the system is suspended. Provide a new core API call
wm97xx_set_suspend_mode() allowing machine drivers to enable this. If no
suspend_mode is provided then the touch panel will be powered down when
the system is suspended.
Signed-off-by: default avatarMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: default avatarDmitry Torokhov <dtor@mail.ru>
parent db7c10e7
......@@ -261,6 +261,23 @@ void wm97xx_config_gpio(struct wm97xx *wm, u32 gpio, enum wm97xx_gpio_dir dir,
}
EXPORT_SYMBOL_GPL(wm97xx_config_gpio);
/*
* Configure the WM97XX_PRP value to use while system is suspended.
* If a value other than 0 is set then WM97xx pen detection will be
* left enabled in the configured mode while the system is in suspend,
* the device has users and suspend has not been disabled via the
* wakeup sysfs entries.
*
* @wm: WM97xx device to configure
* @mode: WM97XX_PRP value to configure while suspended
*/
void wm97xx_set_suspend_mode(struct wm97xx *wm, u16 mode)
{
wm->suspend_mode = mode;
device_init_wakeup(&wm->input_dev->dev, mode != 0);
}
EXPORT_SYMBOL_GPL(wm97xx_set_suspend_mode);
/*
* Handle a pen down interrupt.
*/
......@@ -689,10 +706,32 @@ static int wm97xx_remove(struct device *dev)
static int wm97xx_suspend(struct device *dev, pm_message_t state)
{
struct wm97xx *wm = dev_get_drvdata(dev);
u16 reg;
int suspend_mode;
if (device_may_wakeup(&wm->input_dev->dev))
suspend_mode = wm->suspend_mode;
else
suspend_mode = 0;
if (wm->input_dev->users)
cancel_delayed_work_sync(&wm->ts_reader);
/* Power down the digitiser (bypassing the cache for resume) */
reg = wm97xx_reg_read(wm, AC97_WM97XX_DIGITISER2);
reg &= ~WM97XX_PRP_DET_DIG;
if (wm->input_dev->users)
reg |= suspend_mode;
wm->ac97->bus->ops->write(wm->ac97, AC97_WM97XX_DIGITISER2, reg);
/* WM9713 has an additional power bit - turn it off if there
* are no users or if suspend mode is zero. */
if (wm->id == WM9713_ID2 &&
(!wm->input_dev->users || !suspend_mode)) {
reg = wm97xx_reg_read(wm, AC97_EXTENDED_MID) | 0x8000;
wm97xx_reg_write(wm, AC97_EXTENDED_MID, reg);
}
return 0;
}
......
......@@ -282,6 +282,7 @@ struct wm97xx {
unsigned pen_is_down:1; /* Pen is down */
unsigned aux_waiting:1; /* aux measurement waiting */
unsigned pen_probably_down:1; /* used in polling mode */
u16 suspend_mode; /* PRP in suspend mode */
};
/*
......@@ -297,6 +298,8 @@ void wm97xx_config_gpio(struct wm97xx *wm, u32 gpio,
enum wm97xx_gpio_sticky sticky,
enum wm97xx_gpio_wake wake);
void wm97xx_set_suspend_mode(struct wm97xx *wm, u16 mode);
/* codec AC97 IO access */
int wm97xx_reg_read(struct wm97xx *wm, u16 reg);
void wm97xx_reg_write(struct wm97xx *wm, u16 reg, u16 val);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment