Commit 3f747a81 authored by Peter Ujfalusi's avatar Peter Ujfalusi Committed by Mark Brown

ASoC: tas2552: Add TDM support

TDM support is achieved using DSP transfer mode and setting a programmable
offset which specifies where data begins with respect to the frame sync.
Signed-off-by: default avatarPeter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: default avatarMark Brown <broonie@kernel.org>
parent 1b68c7dc
......@@ -78,6 +78,9 @@ struct tas2552_data {
unsigned char regs[TAS2552_VBAT_DATA];
unsigned int pll_clkin;
unsigned int pdm_clk;
unsigned int dai_fmt;
unsigned int tdm_delay;
};
/* Input mux controls */
......@@ -191,10 +194,29 @@ static int tas2552_hw_params(struct snd_pcm_substream *substream,
#define TAS2552_DAI_FMT_MASK (TAS2552_BCLKDIR | \
TAS2552_WCLKDIR | \
TAS2552_DATAFORMAT_MASK)
static int tas2552_prepare(struct snd_pcm_substream *substream,
struct snd_soc_dai *dai)
{
struct snd_soc_codec *codec = dai->codec;
struct tas2552_data *tas2552 = snd_soc_codec_get_drvdata(codec);
int delay = 0;
/* TDM slot selection only valid in DSP_A/_B mode */
if (tas2552->dai_fmt == SND_SOC_DAIFMT_DSP_A)
delay += (tas2552->tdm_delay + 1);
else if (tas2552->dai_fmt == SND_SOC_DAIFMT_DSP_B)
delay += tas2552->tdm_delay;
/* Configure data delay */
snd_soc_write(codec, TAS2552_SER_CTRL_2, delay);
return 0;
}
static int tas2552_set_dai_fmt(struct snd_soc_dai *dai, unsigned int fmt)
{
struct snd_soc_codec *codec = dai->codec;
u8 delay = 0;
struct tas2552_data *tas2552 = dev_get_drvdata(codec->dev);
u8 serial_format;
switch (fmt & SND_SOC_DAIFMT_MASTER_MASK) {
......@@ -220,7 +242,6 @@ static int tas2552_set_dai_fmt(struct snd_soc_dai *dai, unsigned int fmt)
case (SND_SOC_DAIFMT_I2S | SND_SOC_DAIFMT_NB_NF):
break;
case (SND_SOC_DAIFMT_DSP_A | SND_SOC_DAIFMT_IB_NF):
delay = 1;
case (SND_SOC_DAIFMT_DSP_B | SND_SOC_DAIFMT_IB_NF):
serial_format |= TAS2552_DATAFORMAT_DSP;
break;
......@@ -234,11 +255,10 @@ static int tas2552_set_dai_fmt(struct snd_soc_dai *dai, unsigned int fmt)
dev_vdbg(codec->dev, "DAI Format is not found\n");
return -EINVAL;
}
tas2552->dai_fmt = fmt & SND_SOC_DAIFMT_FORMAT_MASK;
snd_soc_update_bits(codec, TAS2552_SER_CTRL_1, TAS2552_DAI_FMT_MASK,
serial_format);
snd_soc_write(codec, TAS2552_SER_CTRL_2, delay);
return 0;
}
......@@ -278,6 +298,35 @@ static int tas2552_set_dai_sysclk(struct snd_soc_dai *dai, int clk_id,
return 0;
}
static int tas2552_set_dai_tdm_slot(struct snd_soc_dai *dai,
unsigned int tx_mask, unsigned int rx_mask,
int slots, int slot_width)
{
struct snd_soc_codec *codec = dai->codec;
struct tas2552_data *tas2552 = snd_soc_codec_get_drvdata(codec);
unsigned int lsb;
if (unlikely(!tx_mask)) {
dev_err(codec->dev, "tx masks need to be non 0\n");
return -EINVAL;
}
/* TDM based on DSP mode requires slots to be adjacent */
lsb = __ffs(tx_mask);
if ((lsb + 1) != __fls(tx_mask)) {
dev_err(codec->dev, "Invalid mask, slots must be adjacent\n");
return -EINVAL;
}
tas2552->tdm_delay = lsb * slot_width;
/* DOUT in high-impedance on inactive bit clocks */
snd_soc_update_bits(codec, TAS2552_DOUT,
TAS2552_SDOUT_TRISTATE, TAS2552_SDOUT_TRISTATE);
return 0;
}
static int tas2552_mute(struct snd_soc_dai *dai, int mute)
{
u8 cfg1_reg = 0;
......@@ -330,8 +379,10 @@ static const struct dev_pm_ops tas2552_pm = {
static struct snd_soc_dai_ops tas2552_speaker_dai_ops = {
.hw_params = tas2552_hw_params,
.prepare = tas2552_prepare,
.set_sysclk = tas2552_set_dai_sysclk,
.set_fmt = tas2552_set_dai_fmt,
.set_tdm_slot = tas2552_set_dai_tdm_slot,
.digital_mute = tas2552_mute,
};
......
......@@ -62,6 +62,9 @@
#define TAS2552_LIM_EN (1 << 2)
#define TAS2552_IVSENSE_EN (1 << 1)
/* DOUT Register Masks */
#define TAS2552_SDOUT_TRISTATE (1 << 2)
/* Serial Interface Control Register Masks */
#define TAS2552_DATAFORMAT_I2S (0x0 << 2)
#define TAS2552_DATAFORMAT_DSP (0x1 << 2)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment