dt-bindings: serial: document rs485 bindings for various devices

Atmel USART, Freescale UARTs and OMAP UART all support the rs485 binding
described in rs485.txt, this commit just makes that explicit.
Acked-by: Nicolas Ferre <nicolas.ferre@microchip.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Documentation/devicetree/bindings/serial/atmel-usart.txt

@@ -24,6 +24,7 @@ Optional properties:
 	- dma-names: "rx" for RX channel, "tx" for TX channel.
 - atmel,fifo-size: maximum number of data the RX and TX FIFOs can store for FIFO
   capable USARTs.
+- rs485-rts-delay, rs485-rx-during-tx, linux,rs485-enabled-at-boot-time: see rs485.txt
 
 <chip> compatible description:
 - at91rm9200:  legacy USART support

Documentation/devicetree/bindings/serial/fsl-imx-uart.txt

@@ -9,6 +9,7 @@ Optional properties:
 - fsl,irda-mode : Indicate the uart supports irda mode
 - fsl,dte-mode : Indicate the uart works in DTE mode. The uart works
                   in DCE mode by default.
+- rs485-rts-delay, rs485-rx-during-tx, linux,rs485-enabled-at-boot-time: see rs485.txt
 
 Please check Documentation/devicetree/bindings/serial/serial.txt
 for the complete list of generic properties.

Documentation/devicetree/bindings/serial/fsl-lpuart.txt

@@ -16,6 +16,7 @@ Required properties:
 Optional properties:
 - dmas: A list of two dma specifiers, one for each entry in dma-names.
 - dma-names: should contain "tx" and "rx".
+- rs485-rts-delay, rs485-rx-during-tx, linux,rs485-enabled-at-boot-time: see rs485.txt
 
 Note: Optional properties for DMA support. Write them both or both not.
 

Documentation/devicetree/bindings/serial/omap_serial.txt

@@ -19,6 +19,7 @@ Optional properties:
 - dmas : DMA specifier, consisting of a phandle to the DMA controller
          node and a DMA channel number.
 - dma-names : "rx" for receive channel, "tx" for transmit channel.
+- rs485-rts-delay, rs485-rx-during-tx, linux,rs485-enabled-at-boot-time: see rs485.txt
 
 Example: