Commit 4705c1ca authored by Christoph Egger's avatar Christoph Egger Committed by Tony Lindgren

Removing dead OMAP_IR

OMAP_IR doesn't exist in Kconfig, therefore removing all references
for it from the source code.
Signed-off-by: default avatarChristoph Egger <siccegge@cs.fau.de>
[tony@atomide.com: updated for new mux code]
Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
parent 312b80a1
......@@ -292,15 +292,6 @@ static struct platform_device h2_kp_device = {
#define H2_IRDA_FIRSEL_GPIO_PIN 17
#if defined(CONFIG_OMAP_IR) || defined(CONFIG_OMAP_IR_MODULE)
static int h2_transceiver_mode(struct device *dev, int state)
{
/* SIR when low, else MIR/FIR when HIGH */
gpio_set_value(H2_IRDA_FIRSEL_GPIO_PIN, !(state & IR_SIRMODE));
return 0;
}
#endif
static struct omap_irda_config h2_irda_data = {
.transceiver_cap = IR_SIRMODE | IR_MIRMODE | IR_FIRMODE,
.rx_channel = OMAP_DMA_UART3_RX,
......@@ -450,15 +441,6 @@ static void __init h2_init(void)
omap_cfg_reg(E19_1610_KBR4);
omap_cfg_reg(N19_1610_KBR5);
/* Irda */
#if defined(CONFIG_OMAP_IR) || defined(CONFIG_OMAP_IR_MODULE)
omap_writel(omap_readl(FUNC_MUX_CTRL_A) | 7, FUNC_MUX_CTRL_A);
if (gpio_request(H2_IRDA_FIRSEL_GPIO_PIN, "IRDA mode") < 0)
BUG();
gpio_direction_output(H2_IRDA_FIRSEL_GPIO_PIN, 0);
h2_irda_data.transceiver_mode = h2_transceiver_mode;
#endif
platform_add_devices(h2_devices, ARRAY_SIZE(h2_devices));
omap_board_config = h2_config;
omap_board_config_size = ARRAY_SIZE(h2_config);
......
......@@ -356,10 +356,6 @@ static void __init omap_h4_init(void)
* You have to mux them off in device drivers later on
* if not needed.
*/
#if defined(CONFIG_OMAP_IR) || defined(CONFIG_OMAP_IR_MODULE)
omap_mux_init_signal("uart3_tx_irtx.uart3_tx_irtx", 0);
omap_mux_init_signal("uart3_rx_irrx.uart3_rx_irrx", 0);
#endif
#if defined(CONFIG_KEYBOARD_OMAP) || defined(CONFIG_KEYBOARD_OMAP_MODULE)
omap_mux_init_gpio(88, OMAP_PULL_ENA | OMAP_PULL_UP);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment