media: atomisp: get rid of ISP2401_NEW_INPUT_SYSTEM

All ISP2401 devices use the new input system. So, get rid
of the remaining definitions, replacing them by runtime
checks for BYT/CHT when applicable.
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>

drivers/staging/media/atomisp/Makefile

@@ -301,10 +301,8 @@ INCLUDES += \
 	-I$(atomisp)/pci/runtime/rmgr/interface/ \
 	-I$(atomisp)/pci/runtime/spctrl/interface/ \
 	-I$(atomisp)/pci/runtime/tagger/interface/ \
-	-I$(atomisp)/pci/css_2400_system/hive/ \
 	-I$(atomisp)/pci/css_2401_system/ \
 	-I$(atomisp)/pci/css_2401_system/host/ \
-	-I$(atomisp)/pci/css_2401_system/hive/ \
 	-I$(atomisp)/pci/css_2401_system/hrt/
 
 DEFINES := -DHRT_HW -DHRT_ISP_CSS_CUSTOM_HOST -DHRT_USE_VIR_ADDRS -D__HOST__
@@ -319,7 +317,7 @@ ifeq ($(CONFIG_VIDEO_ATOMISP_ISP2401),y)
 atomisp-objs += \
 	$(obj-cht) \
 	pci/runtime/isys/src/ibuf_ctrl_rmgr.o
-DEFINES += -DISP2401 -DISP2401_NEW_INPUT_SYSTEM
+DEFINES += -DISP2401
 endif
 
 ccflags-y += $(INCLUDES) $(DEFINES) -fno-common

drivers/staging/media/atomisp/pci/atomisp_cmd.c

@@ -5156,11 +5156,11 @@ static int css_input_resolution_changed(struct atomisp_sub_device *asd,
 	dev_dbg(asd->isp->dev, "css_input_resolution_changed to %ux%u\n",
 		ffmt->width, ffmt->height);
 
-#if defined(ISP2401_NEW_INPUT_SYSTEM)
+	if (IS_ISP2401)
 		atomisp_css_input_set_two_pixels_per_clock(asd, false);
-#else
+	else
 		atomisp_css_input_set_two_pixels_per_clock(asd, true);
-#endif
+
 	if (asd->continuous_mode->val) {
 		/* Note for all checks: ffmt includes pad_w+pad_h */
 		if (asd->run_mode->val == ATOMISP_RUN_MODE_VIDEO ||
@@ -5494,9 +5494,14 @@ static void atomisp_get_dis_envelop(struct atomisp_sub_device *asd,
 static void atomisp_check_copy_mode(struct atomisp_sub_device *asd,
 				    int source_pad, struct v4l2_pix_format *f)
 {
-#if defined(ISP2401_NEW_INPUT_SYSTEM)
 	struct v4l2_mbus_framefmt *sink, *src;
 
+	if (!IS_ISP2401) {
+		/* Only used for the new input system */
+		asd->copy_mode = false;
+		return;
+	}
+
 	sink = atomisp_subdev_get_ffmt(&asd->subdev, NULL,
 				       V4L2_SUBDEV_FORMAT_ACTIVE, ATOMISP_SUBDEV_PAD_SINK);
 	src = atomisp_subdev_get_ffmt(&asd->subdev, NULL,
@@ -5510,8 +5515,6 @@ static void atomisp_check_copy_mode(struct atomisp_sub_device *asd,
 	      sensor[asd->sensor_curr].stream_num > 1)))
 		asd->copy_mode = true;
 	else
-#endif
-		/* Only used for the new input system */
 		asd->copy_mode = false;
 
 	dev_dbg(asd->isp->dev, "copy_mode: %d\n", asd->copy_mode);

drivers/staging/media/atomisp/pci/atomisp_compat_css20.c

@@ -972,7 +972,7 @@ int atomisp_css_irq_translate(struct atomisp_device *isp,
 void atomisp_css_rx_get_irq_info(enum mipi_port_id port,
 				 unsigned int *infos)
 {
-#ifndef ISP2401_NEW_INPUT_SYSTEM
+#ifndef IS_ISP2401
 	ia_css_isys_rx_get_irq_info(port, infos);
 #else
 	*infos = 0;
@@ -982,7 +982,7 @@ void atomisp_css_rx_get_irq_info(enum mipi_port_id port,
 void atomisp_css_rx_clear_irq_info(enum mipi_port_id port,
 				   unsigned int infos)
 {
-#ifndef ISP2401_NEW_INPUT_SYSTEM
+#ifndef IS_ISP2401
 	ia_css_isys_rx_clear_irq_info(port, infos);
 #endif
 }

drivers/staging/media/atomisp/pci/atomisp_fops.c

@@ -464,13 +464,11 @@ int atomisp_qbuffers_to_css(struct atomisp_sub_device *asd)
 		css_capture_pipe_id = IA_CSS_PIPE_ID_CAPTURE;
 	}
 
-#ifdef ISP2401_NEW_INPUT_SYSTEM
-	if (asd->copy_mode) {
+	if (IS_ISP2401 && asd->copy_mode) {
 		css_capture_pipe_id = IA_CSS_PIPE_ID_COPY;
 		css_preview_pipe_id = IA_CSS_PIPE_ID_COPY;
 		css_video_pipe_id = IA_CSS_PIPE_ID_COPY;
 	}
-#endif
 
 	if (asd->yuvpp_mode) {
 		capture_pipe = &asd->video_out_capture;

drivers/staging/media/atomisp/pci/atomisp_v4l2.c

@@ -1635,12 +1635,7 @@ static int atomisp_pci_probe(struct pci_dev *pdev, const struct pci_device_id *i
 		pdev->d3cold_delay = 0;
 		break;
 	case ATOMISP_PCI_DEVICE_SOC_ANN:
-		isp->media_dev.hw_revision = (
-#ifdef ISP2401_NEW_INPUT_SYSTEM
-						 ATOMISP_HW_REVISION_ISP2401
-#else
-						 ATOMISP_HW_REVISION_ISP2401_LEGACY
-#endif
+		isp->media_dev.hw_revision = (	 ATOMISP_HW_REVISION_ISP2401
 						 << ATOMISP_HW_REVISION_SHIFT);
 		isp->media_dev.hw_revision |= pdev->revision < 2 ?
 					      ATOMISP_HW_STEPPING_A0 : ATOMISP_HW_STEPPING_B0;
@@ -1648,12 +1643,7 @@ static int atomisp_pci_probe(struct pci_dev *pdev, const struct pci_device_id *i
 		isp->hpll_freq = HPLL_FREQ_1600MHZ;
 		break;
 	case ATOMISP_PCI_DEVICE_SOC_CHT:
-		isp->media_dev.hw_revision = (
-#ifdef ISP2401_NEW_INPUT_SYSTEM
-						 ATOMISP_HW_REVISION_ISP2401
-#else
-						 ATOMISP_HW_REVISION_ISP2401_LEGACY
-#endif
+		isp->media_dev.hw_revision = (	 ATOMISP_HW_REVISION_ISP2401
 						 << ATOMISP_HW_REVISION_SHIFT);
 		isp->media_dev.hw_revision |= pdev->revision < 2 ?
 					      ATOMISP_HW_STEPPING_A0 : ATOMISP_HW_STEPPING_B0;