Merge commit 'paulus-perf/master' into next

arch/powerpc/include/asm/pgtable.h

@@ -104,8 +104,8 @@ static inline void __set_pte_at(struct mm_struct *mm, unsigned long addr,
 	else
 		pte_update(ptep, ~_PAGE_HASHPTE, pte_val(pte));
 
-#elif defined(CONFIG_PPC32) && defined(CONFIG_PTE_64BIT) && defined(CONFIG_SMP)
-	/* Second case is 32-bit with 64-bit PTE in SMP mode. In this case, we
+#elif defined(CONFIG_PPC32) && defined(CONFIG_PTE_64BIT)
+	/* Second case is 32-bit with 64-bit PTE.  In this case, we
 	 * can just store as long as we do the two halves in the right order
 	 * with a barrier in between. This is possible because we take care,
 	 * in the hash code, to pre-invalidate if the PTE was already hashed,
@@ -140,7 +140,7 @@ static inline void __set_pte_at(struct mm_struct *mm, unsigned long addr,
 
 #else
 	/* Anything else just stores the PTE normally. That covers all 64-bit
-	 * cases, and 32-bit non-hash with 64-bit PTEs in UP mode
+	 * cases, and 32-bit non-hash with 32-bit PTEs.
 	 */
 	*ptep = pte;
 #endif

arch/powerpc/kernel/Makefile

@@ -97,7 +97,7 @@ obj64-$(CONFIG_AUDIT)		+= compat_audit.o
 
 obj-$(CONFIG_DYNAMIC_FTRACE)	+= ftrace.o
 obj-$(CONFIG_FUNCTION_GRAPH_TRACER)	+= ftrace.o
-obj-$(CONFIG_PPC_PERF_CTRS)	+= perf_counter.o
+obj-$(CONFIG_PPC_PERF_CTRS)	+= perf_counter.o perf_callchain.o
 obj64-$(CONFIG_PPC_PERF_CTRS)	+= power4-pmu.o ppc970-pmu.o power5-pmu.o \
 				   power5+-pmu.o power6-pmu.o power7-pmu.o
 obj32-$(CONFIG_PPC_PERF_CTRS)	+= mpc7450-pmu.o

arch/powerpc/kernel/asm-offsets.c

@@ -69,6 +69,8 @@ int main(void)
 	DEFINE(MMCONTEXTID, offsetof(struct mm_struct, context.id));
 #ifdef CONFIG_PPC64
 	DEFINE(AUDITCONTEXT, offsetof(struct task_struct, audit_context));
+	DEFINE(SIGSEGV, SIGSEGV);
+	DEFINE(NMI_MASK, NMI_MASK);
 #else
 	DEFINE(THREAD_INFO, offsetof(struct task_struct, stack));
 #endif /* CONFIG_PPC64 */

arch/powerpc/kernel/exceptions-64s.S

@@ -731,6 +731,11 @@ BEGIN_FTR_SECTION
 	bne-	do_ste_alloc		/* If so handle it */
 END_FTR_SECTION_IFCLR(CPU_FTR_SLB)
 
+	clrrdi	r11,r1,THREAD_SHIFT
+	lwz	r0,TI_PREEMPT(r11)	/* If we're in an "NMI" */
+	andis.	r0,r0,NMI_MASK@h	/* (i.e. an irq when soft-disabled) */
+	bne	77f			/* then don't call hash_page now */
+
 	/*
 	 * On iSeries, we soft-disable interrupts here, then
 	 * hard-enable interrupts so that the hash_page code can spin on
@@ -835,6 +840,20 @@ handle_page_fault:
 	bl	.low_hash_fault
 	b	.ret_from_except
 
+/*
+ * We come here as a result of a DSI at a point where we don't want
+ * to call hash_page, such as when we are accessing memory (possibly
+ * user memory) inside a PMU interrupt that occurred while interrupts
+ * were soft-disabled.  We want to invoke the exception handler for
+ * the access, or panic if there isn't a handler.
+ */
+77:	bl	.save_nvgprs
+	mr	r4,r3
+	addi	r3,r1,STACK_FRAME_OVERHEAD
+	li	r5,SIGSEGV
+	bl	.bad_page_fault
+	b	.ret_from_except
+
 	/* here we have a segment miss */
 do_ste_alloc:
 	bl	.ste_allocate		/* try to insert stab entry */

arch/powerpc/mm/slb.c

@@ -92,15 +92,13 @@ static inline void create_shadowed_slbe(unsigned long ea, int ssize,
 		     : "memory" );
 }
 
-void slb_flush_and_rebolt(void)
+static void __slb_flush_and_rebolt(void)
 {
 	/* If you change this make sure you change SLB_NUM_BOLTED
 	 * appropriately too. */
 	unsigned long linear_llp, vmalloc_llp, lflags, vflags;
 	unsigned long ksp_esid_data, ksp_vsid_data;
 
-	WARN_ON(!irqs_disabled());
-
 	linear_llp = mmu_psize_defs[mmu_linear_psize].sllp;
 	vmalloc_llp = mmu_psize_defs[mmu_vmalloc_psize].sllp;
 	lflags = SLB_VSID_KERNEL | linear_llp;
@@ -117,12 +115,6 @@ void slb_flush_and_rebolt(void)
 		ksp_vsid_data = get_slb_shadow()->save_area[2].vsid;
 	}
 
-	/*
-	 * We can't take a PMU exception in the following code, so hard
-	 * disable interrupts.
-	 */
-	hard_irq_disable();
-
 	/* We need to do this all in asm, so we're sure we don't touch
 	 * the stack between the slbia and rebolting it. */
 	asm volatile("isync\n"
@@ -139,6 +131,21 @@ void slb_flush_and_rebolt(void)
 		     : "memory");
 }
 
+void slb_flush_and_rebolt(void)
+{
+
+	WARN_ON(!irqs_disabled());
+
+	/*
+	 * We can't take a PMU exception in the following code, so hard
+	 * disable interrupts.
+	 */
+	hard_irq_disable();
+
+	__slb_flush_and_rebolt();
+	get_paca()->slb_cache_ptr = 0;
+}
+
 void slb_vmalloc_update(void)
 {
 	unsigned long vflags;
@@ -180,12 +187,20 @@ static inline int esids_match(unsigned long addr1, unsigned long addr2)
 /* Flush all user entries from the segment table of the current processor. */
 void switch_slb(struct task_struct *tsk, struct mm_struct *mm)
 {
-	unsigned long offset = get_paca()->slb_cache_ptr;
+	unsigned long offset;
 	unsigned long slbie_data = 0;
 	unsigned long pc = KSTK_EIP(tsk);
 	unsigned long stack = KSTK_ESP(tsk);
 	unsigned long exec_base;
 
+	/*
+	 * We need interrupts hard-disabled here, not just soft-disabled,
+	 * so that a PMU interrupt can't occur, which might try to access
+	 * user memory (to get a stack trace) and possible cause an SLB miss
+	 * which would update the slb_cache/slb_cache_ptr fields in the PACA.
+	 */
+	hard_irq_disable();
+	offset = get_paca()->slb_cache_ptr;
 	if (!cpu_has_feature(CPU_FTR_NO_SLBIE_B) &&
 	    offset <= SLB_CACHE_ENTRIES) {
 		int i;
@@ -200,7 +215,7 @@ void switch_slb(struct task_struct *tsk, struct mm_struct *mm)
 		}
 		asm volatile("isync" : : : "memory");
 	} else {
-		slb_flush_and_rebolt();
+		__slb_flush_and_rebolt();
 	}
 
 	/* Workaround POWER5 < DD2.1 issue */

arch/powerpc/mm/stab.c

@@ -164,7 +164,7 @@ void switch_stab(struct task_struct *tsk, struct mm_struct *mm)
 {
 	struct stab_entry *stab = (struct stab_entry *) get_paca()->stab_addr;
 	struct stab_entry *ste;
-	unsigned long offset = __get_cpu_var(stab_cache_ptr);
+	unsigned long offset;
 	unsigned long pc = KSTK_EIP(tsk);
 	unsigned long stack = KSTK_ESP(tsk);
 	unsigned long unmapped_base;
@@ -172,6 +172,15 @@ void switch_stab(struct task_struct *tsk, struct mm_struct *mm)
 	/* Force previous translations to complete. DRENG */
 	asm volatile("isync" : : : "memory");
 
+	/*
+	 * We need interrupts hard-disabled here, not just soft-disabled,
+	 * so that a PMU interrupt can't occur, which might try to access
+	 * user memory (to get a stack trace) and possible cause an STAB miss
+	 * which would update the stab_cache/stab_cache_ptr per-cpu variables.
+	 */
+	hard_irq_disable();
+
+	offset = __get_cpu_var(stab_cache_ptr);
 	if (offset <= NR_STAB_CACHE_ENTRIES) {
 		int i;