i2c: Blackfin TWI: fix REPEAT START mode doesn't repeat

Avoid rewrite TWI MASTER_CTL reg when issue next message
In i2c repeat transfer mode, byte count of next message should be filled
into part of the TWI MASTER_CTL reg when interrupt MCOMP of last
message transfer is triggered. But, other bits in this reg should
not be touched.
Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
Signed-off-by: Bryan Wu <cooloney@kernel.org>
[ben-linux@fluff.org: shorted subject]
Signed-off-by: Ben Dooks <ben-linux@fluff.org>

drivers/i2c/busses/i2c-bfin-twi.c

@@ -196,8 +196,6 @@ static void bfin_twi_handle_interrupt(struct bfin_twi_iface *iface)
 			/* remove restart bit and enable master receive */
 			write_MASTER_CTL(iface,
 				read_MASTER_CTL(iface) & ~RSTART);
-			write_MASTER_CTL(iface,
-				read_MASTER_CTL(iface) | MEN | MDIR);
 			SSYNC();
 		} else if (iface->cur_mode == TWI_I2C_MODE_REPEAT &&
 				iface->cur_msg+1 < iface->msg_num) {
@@ -223,17 +221,18 @@ static void bfin_twi_handle_interrupt(struct bfin_twi_iface *iface)
 
 			if (iface->pmsg[iface->cur_msg].len <= 255)
 					write_MASTER_CTL(iface,
-				iface->pmsg[iface->cur_msg].len << 6);
+					(read_MASTER_CTL(iface) &
+					(~(0xff << 6))) |
+				(iface->pmsg[iface->cur_msg].len << 6));
 			else {
-				write_MASTER_CTL(iface, 0xff << 6);
+				write_MASTER_CTL(iface,
+					(read_MASTER_CTL(iface) |
+					(0xff << 6)));
 				iface->manual_stop = 1;
 			}
 			/* remove restart bit and enable master receive */
 			write_MASTER_CTL(iface,
 				read_MASTER_CTL(iface) & ~RSTART);
-			write_MASTER_CTL(iface, read_MASTER_CTL(iface) |
-				MEN | ((iface->read_write == I2C_SMBUS_READ) ?
-				MDIR : 0));
 			SSYNC();
 		} else {
 			iface->result = 1;