Commit 5a7f08c2 authored by Grygorii Strashko's avatar Grygorii Strashko Committed by David S. Miller

net: phy: dp83867: enable robust auto-mdix

The link detection timeouts can be observed (or link might not be detected
at all) when dp83867 PHY is configured in manual mode (speed/duplex).

CFG3[9] Robust Auto-MDIX option allows to significantly improve link detection
in case dp83867 is configured in manual mode and reduce link detection
time.
As per DM: "If link partners are configured to operational modes that are
not supported by normal Auto MDI/MDIX mode (like Auto-Neg versus Force
100Base-TX or Force 100Base-TX versus Force 100Base-TX), this Robust Auto
MDI/MDIX mode allows MDI/MDIX resolution and prevents deadlock."

Hence, enable this option by default as there are no known reasons
not to do so.
Signed-off-by: default avatarGrygorii Strashko <grygorii.strashko@ti.com>
Reviewed-by: default avatarAndrew Lunn <andrew@lunn.ch>
Reviewed-by: default avatarFlorian Fainelli <f.fainelli@gmail.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 546b85bb
......@@ -95,6 +95,10 @@
#define DP83867_IO_MUX_CFG_CLK_O_SEL_MASK (0x1f << 8)
#define DP83867_IO_MUX_CFG_CLK_O_SEL_SHIFT 8
/* CFG3 bits */
#define DP83867_CFG3_INT_OE BIT(7)
#define DP83867_CFG3_ROBUST_AUTO_MDIX BIT(9)
/* CFG4 bits */
#define DP83867_CFG4_PORT_MIRROR_EN BIT(0)
......@@ -410,12 +414,13 @@ static int dp83867_config_init(struct phy_device *phydev)
phy_write_mmd(phydev, DP83867_DEVADDR, DP83867_SGMIICTL, val);
}
/* Enable Interrupt output INT_OE in CFG3 register */
if (phy_interrupt_is_valid(phydev)) {
val = phy_read(phydev, DP83867_CFG3);
val |= BIT(7);
/* Enable Interrupt output INT_OE in CFG3 register */
if (phy_interrupt_is_valid(phydev))
val |= DP83867_CFG3_INT_OE;
val |= DP83867_CFG3_ROBUST_AUTO_MDIX;
phy_write(phydev, DP83867_CFG3, val);
}
if (dp83867->port_mirroring != DP83867_PORT_MIRROING_KEEP)
dp83867_config_port_mirroring(phydev);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment