iwlwifi: mvm: don't disable power management due to P2P device

Currently power management is supported only when only a single
virtual interface is present. The driver verifies number of created
interfaces and disables power management when multiple interfaces
present. However, this rule does not extend to a P2P device that is
handled differently in the firmware. If a P2P device is added power
management can remain enabled.
Signed-off-by: Alexander Bondar <alexander.bondar@intel.com>
Reviewed-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>

drivers/net/wireless/iwlwifi/mvm/mac80211.c

@@ -502,10 +502,14 @@ static int iwl_mvm_mac_add_interface(struct ieee80211_hw *hw,
 	/*
 	 * TODO: remove this temporary code.
 	 * Currently MVM FW supports power management only on single MAC.
-	 * Iterate and disable PM on all active interfaces.
+	 * If new interface added, disable PM on existing interface.
+	 * P2P device is a special case, since it is handled by FW similary to
+	 * scan. If P2P deviced is added, PM remains enabled on existing
+	 * interface.
 	 * Note: the method below does not count the new interface being added
 	 * at this moment.
 	 */
+	if (vif->type != NL80211_IFTYPE_P2P_DEVICE)
 		mvm->vif_count++;
 	if (mvm->vif_count > 1) {
 		IWL_DEBUG_MAC80211(mvm,
@@ -576,9 +580,10 @@ static int iwl_mvm_mac_add_interface(struct ieee80211_hw *hw,
 	/*
 	 * TODO: remove this temporary code.
 	 * Currently MVM FW supports power management only on single MAC.
-	 * Check if only one additional interface remains after rereasing
+	 * Check if only one additional interface remains after releasing
 	 * current one. Update power mode on the remaining interface.
 	 */
+	if (vif->type != NL80211_IFTYPE_P2P_DEVICE)
 		mvm->vif_count--;
 	IWL_DEBUG_MAC80211(mvm, "Currently %d interfaces active\n",
 			   mvm->vif_count);
@@ -666,7 +671,7 @@ static void iwl_mvm_mac_remove_interface(struct ieee80211_hw *hw,
 	 * Check if only one additional interface remains after removing
 	 * current one. Update power mode on the remaining interface.
 	 */
-	if (mvm->vif_count)
+	if (mvm->vif_count && vif->type != NL80211_IFTYPE_P2P_DEVICE)
 		mvm->vif_count--;
 	IWL_DEBUG_MAC80211(mvm, "Currently %d interfaces active\n",
 			   mvm->vif_count);

drivers/net/wireless/iwlwifi/mvm/mvm.h

@@ -322,6 +322,13 @@ struct iwl_mvm {
 	 * can hold 16 keys at most. Reflect this fact.
 	 */
 	unsigned long fw_key_table[BITS_TO_LONGS(STA_KEY_MAX_NUM)];
+
+	/*
+	 * This counter of created interfaces is referenced only in conjunction
+	 * with FW limitation related to power management. Currently PM is
+	 * supported only on a single interface.
+	 * IMPORTANT: this variable counts all interfaces except P2P device.
+	 */
 	u8 vif_count;
 
 	struct led_classdev led;