[PATCH] e1000 3/7: Determine link status correctly while using

drivers/net/e1000/e1000_hw.c

@@ -470,7 +470,6 @@ e1000_init_hw(struct e1000_hw *hw)
     uint16_t pcix_stat_hi_word;
     uint16_t cmd_mmrbc;
     uint16_t stat_mmrbc;
-
     DEBUGFUNC("e1000_init_hw");
 
     /* Initialize Identification LED */
@@ -1967,7 +1966,7 @@ e1000_config_fc_after_link_up(struct e1000_hw *hw)
 int32_t
 e1000_check_for_link(struct e1000_hw *hw)
 {
-    uint32_t rxcw;
+    uint32_t rxcw = 0;
     uint32_t ctrl;
     uint32_t status;
     uint32_t rctl;
@@ -1977,17 +1976,24 @@ e1000_check_for_link(struct e1000_hw *hw)
 
     DEBUGFUNC("e1000_check_for_link");
 
+    ctrl = E1000_READ_REG(hw, CTRL);
+    status = E1000_READ_REG(hw, STATUS);
+
     /* On adapters with a MAC newer than 82544, SW Defineable pin 1 will be
      * set when the optics detect a signal. On older adapters, it will be
      * cleared when there is a signal.  This applies to fiber media only.
      */
-    if(hw->media_type == e1000_media_type_fiber)
-        signal = (hw->mac_type > e1000_82544) ? E1000_CTRL_SWDPIN1 : 0;
-
-    ctrl = E1000_READ_REG(hw, CTRL);
-    status = E1000_READ_REG(hw, STATUS);
+    if((hw->media_type == e1000_media_type_fiber) ||
+       (hw->media_type == e1000_media_type_internal_serdes)) {
         rxcw = E1000_READ_REG(hw, RXCW);
 
+        if(hw->media_type == e1000_media_type_fiber) {
+            signal = (hw->mac_type > e1000_82544) ? E1000_CTRL_SWDPIN1 : 0;
+            if(status & E1000_STATUS_LU)
+                hw->get_link_status = FALSE;
+        }
+    }
+
     /* If we have a copper PHY then we only want to go out to the PHY
      * registers to see if Auto-Neg has completed and/or if our link
      * status has changed.  The get_link_status flag will be set if we
@@ -2131,8 +2137,7 @@ e1000_check_for_link(struct e1000_hw *hw)
      */
     else if(((hw->media_type == e1000_media_type_fiber) ||
              (hw->media_type == e1000_media_type_internal_serdes)) &&
-              (ctrl & E1000_CTRL_SLU) &&
-              (rxcw & E1000_RXCW_C)) {
+            (ctrl & E1000_CTRL_SLU) && (rxcw & E1000_RXCW_C)) {
         DEBUGOUT("RXing /C/, enable AutoNeg and stop forcing link.\r\n");
         E1000_WRITE_REG(hw, TXCW, hw->txcw);
         E1000_WRITE_REG(hw, CTRL, (ctrl & ~E1000_CTRL_SLU));