Commit 66e3bc4a authored by Georgii Staroselskii's avatar Georgii Staroselskii Committed by Maxime Ripard

ARM: dts: sunxi: Add Neutis N5H3 support

Emlid Neutis N5H3 is a version of Emlid Neutis SoM with H3 instead of H5
inside.

6eeb4180 ("ARM: dts: sunxi: h3-h5: Add Bananapi M2+ v1.2 device")
was used as reference.
Signed-off-by: default avatarGeorgii Staroselskii <georgii.staroselskii@emlid.com>
Signed-off-by: default avatarMaxime Ripard <maxime@cerno.tech>
parent e69f2736
...@@ -1129,6 +1129,7 @@ dtb-$(CONFIG_MACH_SUN8I) += \ ...@@ -1129,6 +1129,7 @@ dtb-$(CONFIG_MACH_SUN8I) += \
sun8i-h3-orangepi-plus2e.dtb \ sun8i-h3-orangepi-plus2e.dtb \
sun8i-h3-orangepi-zero-plus2.dtb \ sun8i-h3-orangepi-zero-plus2.dtb \
sun8i-h3-rervision-dvk.dtb \ sun8i-h3-rervision-dvk.dtb \
sun8i-h3-emlid-neutis-n5h3-devboard.dtb \
sun8i-r16-bananapi-m2m.dtb \ sun8i-r16-bananapi-m2m.dtb \
sun8i-r16-nintendo-nes-classic.dtb \ sun8i-r16-nintendo-nes-classic.dtb \
sun8i-r16-nintendo-super-nes-classic.dtb \ sun8i-r16-nintendo-super-nes-classic.dtb \
......
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/*
* DTS for Emlid Neutis N5 Dev board.
*
* Copyright (C) 2019 Georgii Staroselskii <georgiii.staroselskii@emlid.com>
*/
/dts-v1/;
#include "sun8i-h3-emlid-neutis-n5h3.dtsi"
/ {
model = "Emlid Neutis N5H3 Developer board";
compatible = "emlid,neutis-n5h3-devboard",
"emlid,neutis-n5h3",
"allwinner,sun8i-h3";
vdd_cpux: gpio-regulator {
compatible = "regulator-gpio";
regulator-name = "vdd-cpux";
regulator-type = "voltage";
regulator-boot-on;
regulator-always-on;
regulator-min-microvolt = <1100000>;
regulator-max-microvolt = <1300000>;
regulator-ramp-delay = <50>; /* 4ms */
gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>; /* PL6 */
gpios-states = <0x1>;
states = <1100000 0x0>, <1300000 0x1>;
};
connector {
compatible = "hdmi-connector";
type = "a";
port {
hdmi_con_in: endpoint {
remote-endpoint = <&hdmi_out_con>;
};
};
};
};
&cpu0 {
cpu-supply = <&vdd_cpux>;
};
&codec {
status = "okay";
};
&emac {
phy-handle = <&int_mii_phy>;
phy-mode = "mii";
allwinner,leds-active-low;
status = "okay";
};
&hdmi {
status = "okay";
};
&hdmi_out {
hdmi_out_con: endpoint {
remote-endpoint = <&hdmi_con_in>;
};
};
&i2c1 {
status = "okay";
};
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/*
* DTSI for Emlid Neutis N5 SoM.
*
* Copyright (C) 2019 Georgii Staroselskii <georgii.staroselskii@emlid.com>
*/
/dts-v1/;
#include "sun8i-h3.dtsi"
#include <arm/sunxi-h3-h5-emlid-neutis.dtsi>
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment