net: bcmgenet: Remove excessive PHY reset

We are currently issuing multiple PHY resets during a suspend/resume,
first during bcmgenet_power_up() which does a hardware reset, then a
software reset by calling bcmgenet_mii_reset(). This is both unnecessary
and can take as long as 10ms per MDIO transactions while we re-apply
workarounds because we do not yet have MDIO interrupts enabled.

phy_resume() takes care of re-apply our workarounds in case we need any,
and bcmgenet_power_up() does a PHY hardware reset, all of this is more
than enough to guarantee that the PHY operates correctly.

Fixes: 1c1008c7 ("net: bcmgenet: add main driver file")
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/broadcom/genet/bcmgenet.c

@@ -907,9 +907,6 @@ static void bcmgenet_power_up(struct bcmgenet_priv *priv,
 	}
 
 	bcmgenet_ext_writel(priv, reg, EXT_EXT_PWR_MGMT);
-
-	if (mode == GENET_POWER_PASSIVE)
-		bcmgenet_mii_reset(priv->dev);
 }
 
 /* ioctl handle special commands that are not present in ethtool. */

drivers/net/ethernet/broadcom/genet/bcmgenet.h

@@ -672,7 +672,6 @@ GENET_IO_MACRO(rbuf, GENET_RBUF_OFF);
 int bcmgenet_mii_init(struct net_device *dev);
 int bcmgenet_mii_config(struct net_device *dev, bool init);
 void bcmgenet_mii_exit(struct net_device *dev);
-void bcmgenet_mii_reset(struct net_device *dev);
 void bcmgenet_phy_power_set(struct net_device *dev, bool enable);
 void bcmgenet_mii_setup(struct net_device *dev);
 

drivers/net/ethernet/broadcom/genet/bcmmii.c

@@ -163,16 +163,6 @@ void bcmgenet_mii_setup(struct net_device *dev)
 	phy_print_status(phydev);
 }
 
-void bcmgenet_mii_reset(struct net_device *dev)
-{
-	struct bcmgenet_priv *priv = netdev_priv(dev);
-
-	if (priv->phydev) {
-		phy_init_hw(priv->phydev);
-		phy_start_aneg(priv->phydev);
-	}
-}
-
 void bcmgenet_phy_power_set(struct net_device *dev, bool enable)
 {
 	struct bcmgenet_priv *priv = netdev_priv(dev);
@@ -215,7 +205,6 @@ static void bcmgenet_internal_phy_setup(struct net_device *dev)
 	reg = bcmgenet_ext_readl(priv, EXT_EXT_PWR_MGMT);
 	reg |= EXT_PWR_DN_EN_LD;
 	bcmgenet_ext_writel(priv, reg, EXT_EXT_PWR_MGMT);
-	bcmgenet_mii_reset(dev);
 }
 
 static void bcmgenet_moca_phy_setup(struct bcmgenet_priv *priv)