Merge tag 'imx-fixes-6.0-2' of...

Merge tag 'imx-fixes-6.0-2' of git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux into arm/fixes

i.MX fixes for 6.0, 2nd round:

- A couple of TQMa8MPQL device tree fixes from Alexander Stein on button
  GPIOs and PCF85063 RTC alarm pinctrl.
- Include phy-imx8-pcie.h header in tqma8mqml-mba8mx device tree to fix
  build errors when this SoM dtsi is included on customer carrier boards.
- Remove GPU power domain reset from i.MX8MN device tree to fix
  a sporadical hang seen with GPUMIX powering up.
- Correct CPLD_Dn GPIO label mapping for Toradex Verdin based Menlo
  board.
- Add ARCH_NXP back to defconfig, which was dropped accidentally by
  commit 566e373f ("arm64: Kconfig.platforms: Group NXP platforms
  together").
- Add missing #reset-cells for i.MX8ULP PCC clock controllers.
- Update PMIC voltages for imx8mm-verdin board to fix an issue with one
  Toradex SKU that uses a consumer-grade chip that is capable of going up
  to 1.8GHz at 1.00V.
- A series of imx8mp-venice-gw74xx device tree changes from Tim Harvey
  to fix things on CAN STBY polarity, KSZ9477 CPU uplink port and
  phy-mode.

* tag 'imx-fixes-6.0-2' of git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux:
  arm64: dts: imx8mp-venice-gw74xx: fix port/phy validation
  arm64: dts: imx8mp-venice-gw74xx: fix ksz9477 cpu port
  arm64: dts: imx8mp-venice-gw74xx: fix CAN STBY polarity
  arm64: dts: tqma8mqml: Include phy-imx8-pcie.h header
  arm64: defconfig: enable ARCH_NXP
  arm64: dts: imx8mp-tqma8mpql-mba8mpxl: add missing pinctrl for RTC alarm
  arm64: dts: imx8mm-verdin: extend pmic voltages
  arm64: dts: imx8ulp: add #reset-cells for pcc
  arm64: dts: tqma8mpxl-ba8mpxl: Fix button GPIOs
  arm64: dts: imx8mn: remove GPU power domain reset
  arm64: dts: imx8mm: Reverse CPLD_Dn GPIO label mapping on MX8Menlo
Signed-off-by: Arnd Bergmann <arnd@arndb.de>

arch/arm64/boot/dts/freescale/imx8mm-mx8menlo.dts

@@ -152,11 +152,11 @@ &gpio4 {
 	 * CPLD_reset is RESET_SOFT in schematic
 	 */
 	gpio-line-names =
-		"CPLD_D[1]", "CPLD_int", "CPLD_reset", "",
-		"", "CPLD_D[0]", "", "",
-		"", "", "", "CPLD_D[2]",
-		"CPLD_D[3]", "CPLD_D[4]", "CPLD_D[5]", "CPLD_D[6]",
-		"CPLD_D[7]", "", "", "",
+		"CPLD_D[6]", "CPLD_int", "CPLD_reset", "",
+		"", "CPLD_D[7]", "", "",
+		"", "", "", "CPLD_D[5]",
+		"CPLD_D[4]", "CPLD_D[3]", "CPLD_D[2]", "CPLD_D[1]",
+		"CPLD_D[0]", "", "", "",
 		"", "", "", "",
 		"", "", "", "KBD_intK",
 		"", "", "", "";

arch/arm64/boot/dts/freescale/imx8mm-tqma8mqml-mba8mx.dts

@@ -5,7 +5,6 @@
 
 /dts-v1/;
 
-#include <dt-bindings/phy/phy-imx8-pcie.h>
 #include "imx8mm-tqma8mqml.dtsi"
 #include "mba8mx.dtsi"
 

arch/arm64/boot/dts/freescale/imx8mm-tqma8mqml.dtsi

@@ -3,6 +3,7 @@
  * Copyright 2020-2021 TQ-Systems GmbH
  */
 
+#include <dt-bindings/phy/phy-imx8-pcie.h>
 #include "imx8mm.dtsi"
 
 / {

arch/arm64/boot/dts/freescale/imx8mm-verdin.dtsi

@@ -367,8 +367,8 @@ reg_vdd_arm: BUCK2 {
 				nxp,dvs-standby-voltage = <850000>;
 				regulator-always-on;
 				regulator-boot-on;
-				regulator-max-microvolt = <950000>;
-				regulator-min-microvolt = <850000>;
+				regulator-max-microvolt = <1050000>;
+				regulator-min-microvolt = <805000>;
 				regulator-name = "On-module +VDD_ARM (BUCK2)";
 				regulator-ramp-delay = <3125>;
 			};
@@ -376,8 +376,8 @@ reg_vdd_arm: BUCK2 {
 			reg_vdd_dram: BUCK3 {
 				regulator-always-on;
 				regulator-boot-on;
-				regulator-max-microvolt = <950000>;
-				regulator-min-microvolt = <850000>;
+				regulator-max-microvolt = <1000000>;
+				regulator-min-microvolt = <805000>;
 				regulator-name = "On-module +VDD_GPU_VPU_DDR (BUCK3)";
 			};
 
@@ -416,7 +416,7 @@ reg_nvcc_snvs: LDO1 {
 			reg_vdd_snvs: LDO2 {
 				regulator-always-on;
 				regulator-boot-on;
-				regulator-max-microvolt = <900000>;
+				regulator-max-microvolt = <800000>;
 				regulator-min-microvolt = <800000>;
 				regulator-name = "On-module +V0.8_SNVS (LDO2)";
 			};

arch/arm64/boot/dts/freescale/imx8mn.dtsi

@@ -672,7 +672,6 @@ pgc_gpumix: power-domain@2 {
 							 <&clk IMX8MN_CLK_GPU_SHADER>,
 							 <&clk IMX8MN_CLK_GPU_BUS_ROOT>,
 							 <&clk IMX8MN_CLK_GPU_AHB>;
-						resets = <&src IMX8MQ_RESET_GPU_RESET>;
 					};
 
 					pgc_dispmix: power-domain@3 {

arch/arm64/boot/dts/freescale/imx8mp-tqma8mpql-mba8mpxl.dts

@@ -57,13 +57,13 @@ gpio-keys {
 		switch-1 {
 			label = "S12";
 			linux,code = <BTN_0>;
-			gpios = <&gpio5 26 GPIO_ACTIVE_LOW>;
+			gpios = <&gpio5 27 GPIO_ACTIVE_LOW>;
 		};
 
 		switch-2 {
 			label = "S13";
 			linux,code = <BTN_1>;
-			gpios = <&gpio5 27 GPIO_ACTIVE_LOW>;
+			gpios = <&gpio5 26 GPIO_ACTIVE_LOW>;
 		};
 	};
 
@@ -394,6 +394,8 @@ &i2c6 {
 
 &pcf85063 {
 	/* RTC_EVENT# is connected on MBa8MPxL */
+	pinctrl-names = "default";
+	pinctrl-0 = <&pinctrl_pcf85063>;
 	interrupt-parent = <&gpio4>;
 	interrupts = <28 IRQ_TYPE_EDGE_FALLING>;
 };
@@ -630,6 +632,10 @@ pinctrl_lvdsdisplay: lvdsdisplaygrp {
 		fsl,pins = <MX8MP_IOMUXC_SAI5_RXC__GPIO3_IO20		0x10>; /* Power enable */
 	};
 
+	pinctrl_pcf85063: pcf85063grp {
+		fsl,pins = <MX8MP_IOMUXC_SAI3_RXFS__GPIO4_IO28		0x80>;
+	};
+
 	/* LVDS Backlight */
 	pinctrl_pwm2: pwm2grp {
 		fsl,pins = <MX8MP_IOMUXC_SAI5_RXD0__PWM2_OUT		0x14>;

arch/arm64/boot/dts/freescale/imx8mp-venice-gw74xx.dts

@@ -123,8 +123,7 @@ reg_can2_stby: regulator-can2-stby {
 		pinctrl-names = "default";
 		pinctrl-0 = <&pinctrl_reg_can>;
 		regulator-name = "can2_stby";
-		gpio = <&gpio3 19 GPIO_ACTIVE_HIGH>;
-		enable-active-high;
+		gpio = <&gpio3 19 GPIO_ACTIVE_LOW>;
 		regulator-min-microvolt = <3300000>;
 		regulator-max-microvolt = <3300000>;
 	};
@@ -484,35 +483,40 @@ ports {
 			lan1: port@0 {
 				reg = <0>;
 				label = "lan1";
+				phy-mode = "internal";
 				local-mac-address = [00 00 00 00 00 00];
 			};
 
 			lan2: port@1 {
 				reg = <1>;
 				label = "lan2";
+				phy-mode = "internal";
 				local-mac-address = [00 00 00 00 00 00];
 			};
 
 			lan3: port@2 {
 				reg = <2>;
 				label = "lan3";
+				phy-mode = "internal";
 				local-mac-address = [00 00 00 00 00 00];
 			};
 
 			lan4: port@3 {
 				reg = <3>;
 				label = "lan4";
+				phy-mode = "internal";
 				local-mac-address = [00 00 00 00 00 00];
 			};
 
 			lan5: port@4 {
 				reg = <4>;
 				label = "lan5";
+				phy-mode = "internal";
 				local-mac-address = [00 00 00 00 00 00];
 			};
 
-			port@6 {
-				reg = <6>;
+			port@5 {
+				reg = <5>;
 				label = "cpu";
 				ethernet = <&fec>;
 				phy-mode = "rgmii-id";

arch/arm64/boot/dts/freescale/imx8ulp.dtsi

@@ -172,6 +172,7 @@ pcc3: clock-controller@292d0000 {
 				compatible = "fsl,imx8ulp-pcc3";
 				reg = <0x292d0000 0x10000>;
 				#clock-cells = <1>;
+				#reset-cells = <1>;
 			};
 
 			tpm5: tpm@29340000 {
@@ -270,6 +271,7 @@ pcc4: clock-controller@29800000 {
 				compatible = "fsl,imx8ulp-pcc4";
 				reg = <0x29800000 0x10000>;
 				#clock-cells = <1>;
+				#reset-cells = <1>;
 			};
 
 			lpi2c6: i2c@29840000 {
@@ -414,6 +416,7 @@ pcc5: clock-controller@2da70000 {
 				compatible = "fsl,imx8ulp-pcc5";
 				reg = <0x2da70000 0x10000>;
 				#clock-cells = <1>;
+				#reset-cells = <1>;
 			};
 		};
 

arch/arm64/configs/defconfig

@@ -48,6 +48,7 @@ CONFIG_ARCH_KEEMBAY=y
 CONFIG_ARCH_MEDIATEK=y
 CONFIG_ARCH_MESON=y
 CONFIG_ARCH_MVEBU=y
+CONFIG_ARCH_NXP=y
 CONFIG_ARCH_MXC=y
 CONFIG_ARCH_NPCM=y
 CONFIG_ARCH_QCOM=y