usb: musb: Stop bulk endpoint while queue is rotated

BugLink: http://bugs.launchpad.net/bugs/1601952

commit 7b2c17f8 upstream.

Ensure that the endpoint is stopped by clearing REQPKT before
clearing DATAERR_NAKTIMEOUT before rotating the queue on the
dedicated bulk endpoint.
This addresses an issue where a race could result in the endpoint
receiving data before it was reprogrammed resulting in a warning
about such data from musb_rx_reinit before it was thrown away.
The data thrown away was a valid packet that had been correctly
ACKed which meant the host and device got out of sync.
Signed-off-by: Andrew Goodbody <andrew.goodbody@cambrionix.com>
Signed-off-by: Bin Liu <b-liu@ti.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Signed-off-by: Tim Gardner <tim.gardner@canonical.com>
Signed-off-by: Kamal Mostafa <kamal@canonical.com>

drivers/usb/musb/musb_host.c

@@ -995,9 +995,15 @@ static void musb_bulk_nak_timeout(struct musb *musb, struct musb_hw_ep *ep,
 	if (is_in) {
 		dma = is_dma_capable() ? ep->rx_channel : NULL;
 
-		/* clear nak timeout bit */
+		/*
+		 * Need to stop the transaction by clearing REQPKT first
+		 * then the NAK Timeout bit ref MUSBMHDRC USB 2.0 HIGH-SPEED
+		 * DUAL-ROLE CONTROLLER Programmer's Guide, section 9.2.2
+		 */
 		rx_csr = musb_readw(epio, MUSB_RXCSR);
 		rx_csr |= MUSB_RXCSR_H_WZC_BITS;
+		rx_csr &= ~MUSB_RXCSR_H_REQPKT;
+		musb_writew(epio, MUSB_RXCSR, rx_csr);
 		rx_csr &= ~MUSB_RXCSR_DATAERROR;
 		musb_writew(epio, MUSB_RXCSR, rx_csr);