dt-bindings: pinctrl: qcom,qcm2290: fix matching pin config

The TLMM pin controller follows generic pin-controller bindings, so
should have subnodes with '-state' and '-pins'.  Otherwise the subnodes
(level one and two) are not properly matched.  This method also unifies
the bindings with other Qualcomm TLMM and LPASS pinctrl bindings.
Reviewed-by: Bjorn Andersson <andersson@kernel.org>
Reviewed-by: Rob Herring <robh@kernel.org>
Link: https://lore.kernel.org/r/20221016170035.35014-27-krzysztof.kozlowski@linaro.orgSigned-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>

Documentation/devicetree/bindings/pinctrl/qcom,qcm2290-pinctrl.yaml

@@ -50,8 +50,9 @@ patternProperties:
     oneOf:
       - $ref: "#/$defs/qcom-qcm2290-tlmm-state"
       - patternProperties:
-          ".*":
+          "-pins$":
             $ref: "#/$defs/qcom-qcm2290-tlmm-state"
+        additionalProperties: false
 
 '$defs':
   qcom-qcm2290-tlmm-state:
@@ -146,19 +147,19 @@ examples:
         gpio-ranges = <&tlmm 0 0 127>;
 
         sdc2_on_state: sdc2-on-state {
-            clk {
+            clk-pins {
                 pins = "sdc2_clk";
                 bias-disable;
                 drive-strength = <16>;
             };
 
-            cmd {
+            cmd-pins {
                 pins = "sdc2_cmd";
                 bias-pull-up;
                 drive-strength = <10>;
             };
 
-            data {
+            data-pins {
                 pins = "sdc2_data";
                 bias-pull-up;
                 drive-strength = <10>;