media: rdacm20: Enable GPIO1 explicitly

The MAX9271 GPIO1 line that controls the sensor reset is by default
enabled after a serializer chip reset.

As rdacm20 does not go through an explicit serializer reset, make sure
GPIO1 is enabled to make the camera module driver more robust.

Fixes: 34009bff ("media: i2c: Add RDACM20 driver")
Signed-off-by: Jacopo Mondi <jacopo+renesas@jmondi.org>
Reviewed-by: Kieran Bingham <kieran.bingham+renesas@ideasonboard.com>
Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>

drivers/media/i2c/rdacm20.c

@@ -487,9 +487,18 @@ static int rdacm20_initialize(struct rdacm20_device *dev)
 	 * Reset the sensor by cycling the OV10635 reset signal connected to the
 	 * MAX9271 GPIO1 and verify communication with the OV10635.
 	 */
-	max9271_clear_gpios(dev->serializer, MAX9271_GPIO1OUT);
+	ret = max9271_enable_gpios(dev->serializer, MAX9271_GPIO1OUT);
+	if (ret)
+		return ret;
+
+	ret = max9271_clear_gpios(dev->serializer, MAX9271_GPIO1OUT);
+	if (ret)
+		return ret;
 	usleep_range(10000, 15000);
-	max9271_set_gpios(dev->serializer, MAX9271_GPIO1OUT);
+
+	ret = max9271_set_gpios(dev->serializer, MAX9271_GPIO1OUT);
+	if (ret)
+		return ret;
 	usleep_range(10000, 15000);
 
 again: