[media] V4L: Add driver for OV9650/52 image sensors

This patch adds V4L2 sub-device driver for OV9650/OV9652 image sensors.
The driver exposes following V4L2 controls:
- auto/manual exposure,
- auto/manual white balance,
- auto/manual gain,
- brightness, saturation, sharpness,
- horizontal/vertical flip,
- color bar test pattern,
- banding filter (power line frequency).
Frame rate can be configured with g/s_frame_interval pad level ops.
Supported resolution are only: SXGA, VGA, QVGA.
Signed-off-by: Sylwester Nawrocki <sylvester.nawrocki@gmail.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>

drivers/media/i2c/Kconfig

@@ -421,6 +421,13 @@ config VIDEO_OV7670
 	  OV7670 VGA camera.  It currently only works with the M88ALP01
 	  controller.
 
+config VIDEO_OV9650
+	tristate "OmniVision OV9650/OV9652 sensor support"
+	depends on I2C && VIDEO_V4L2 && VIDEO_V4L2_SUBDEV_API
+	---help---
+	  This is a V4L2 sensor-level driver for the Omnivision
+	  OV9650 and OV9652 camera sensors.
+
 config VIDEO_VS6624
 	tristate "ST VS6624 sensor support"
 	depends on VIDEO_V4L2 && I2C

drivers/media/i2c/Makefile

@@ -47,6 +47,7 @@ obj-$(CONFIG_VIDEO_VP27SMPX) += vp27smpx.o
 obj-$(CONFIG_VIDEO_UPD64031A) += upd64031a.o
 obj-$(CONFIG_VIDEO_UPD64083) += upd64083.o
 obj-$(CONFIG_VIDEO_OV7670) 	+= ov7670.o
+obj-$(CONFIG_VIDEO_OV9650) += ov9650.o
 obj-$(CONFIG_VIDEO_TCM825X) += tcm825x.o
 obj-$(CONFIG_VIDEO_TVEEPROM) += tveeprom.o
 obj-$(CONFIG_VIDEO_MT9M032) += mt9m032.o

include/media/ov9650.h

+/*
+ * OV9650/OV9652 camera sensors driver
+ *
+ * Copyright (C) 2013 Sylwester Nawrocki <sylvester.nawrocki@gmail.com>
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ */
+#ifndef OV9650_H_
+#define OV9650_H_
+
+/**
+ * struct ov9650_platform_data - ov9650 driver platform data
+ * @mclk_frequency: the sensor's master clock frequency in Hz
+ * @gpio_pwdn:	    number of a GPIO connected to OV965X PWDN pin
+ * @gpio_reset:     number of a GPIO connected to OV965X RESET pin
+ *
+ * If any of @gpio_pwdn or @gpio_reset are unused then they should be
+ * set to a negative value. @mclk_frequency must always be specified.
+ */
+struct ov9650_platform_data {
+	unsigned long mclk_frequency;
+	int gpio_pwdn;
+	int gpio_reset;
+};
+#endif /* OV9650_H_ */