iio: dht11: whitespace changes to make checkpatch.pl --strict happy

* add spaces around binary operators in cases where it reduces readability
* align multiline statements around opening parenthesis
Reported-by: Hartmut Knaack <knaack.h@gmx.de>
	in Message-ID: <55919E72.3010807@gmx.de>
Signed-off-by: Harald Geyer <harald@ccbib.org>
Signed-off-by: Jonathan Cameron <jic23@kernel.org>

drivers/iio/humidity/dht11.c

@@ -46,7 +46,8 @@
  * Note that when reading the sensor actually 84 edges are detected, but
  * since the last edge is not significant, we only store 83:
  */
-#define DHT11_EDGES_PER_READ (2*DHT11_BITS_PER_READ + DHT11_EDGES_PREAMBLE + 1)
+#define DHT11_EDGES_PER_READ (2 * DHT11_BITS_PER_READ + \
+			      DHT11_EDGES_PREAMBLE + 1)
 
 /* Data transmission timing (nano seconds) */
 #define DHT11_START_TRANSMISSION	18  /* ms */
@@ -95,24 +96,24 @@ static int dht11_decode(struct dht11 *dht11, int offset)
 
 	/* Calculate timestamp resolution */
 	for (i = 1; i < dht11->num_edges; ++i) {
-		t = dht11->edges[i].ts - dht11->edges[i-1].ts;
+		t = dht11->edges[i].ts - dht11->edges[i - 1].ts;
 		if (t > 0 && t < timeres)
 			timeres = t;
 	}
-	if (2*timeres > DHT11_DATA_BIT_HIGH) {
+	if (2 * timeres > DHT11_DATA_BIT_HIGH) {
 		pr_err("dht11: timeresolution %d too bad for decoding\n",
 		       timeres);
 		return -EIO;
 	}
 	threshold = DHT11_DATA_BIT_HIGH / timeres;
-	if (DHT11_DATA_BIT_LOW/timeres + 1 >= threshold)
+	if (DHT11_DATA_BIT_LOW / timeres + 1 >= threshold)
 		pr_err("dht11: WARNING: decoding ambiguous\n");
 
 	/* scale down with timeres and check validity */
 	for (i = 0; i < DHT11_BITS_PER_READ; ++i) {
-		t = dht11->edges[offset + 2*i + 2].ts -
-			dht11->edges[offset + 2*i + 1].ts;
-		if (!dht11->edges[offset + 2*i + 1].value)
+		t = dht11->edges[offset + 2 * i + 2].ts -
+			dht11->edges[offset + 2 * i + 1].ts;
+		if (!dht11->edges[offset + 2 * i + 1].value)
 			return -EIO;  /* lost synchronisation */
 		timing[i] = t / timeres;
 	}