pinctrl/amd: only handle irq if it is pending and unmasked

The AMD pinctrl driver demultiplexes GPIO interrupts and fires off their
individual handlers.

If one of these GPIO irqs is configured as a level interrupt, and its
downstream handler is a threaded ONESHOT interrupt, the GPIO interrupt
source is masked by handle_level_irq() until the eventual return of the
threaded irq handler.  During this time the level GPIO interrupt status
will still report as high until the actual gpio source is cleared - both
in the individual GPIO interrupt status bit (INTERRUPT_STS_OFF) and in
its corresponding "WAKE_INT_STATUS_REG" bit.

Thus, if another GPIO interrupt occurs during this time,
amd_gpio_irq_handler() will see that the (masked-and-not-yet-cleared)
level irq is still pending and incorrectly call its handler again.

To fix this, have amd_gpio_irq_handler() check for both interrupts status
and mask before calling generic_handle_irq().

Note: Is it possible that this bug was the source of the interrupt storm
on Ryzen when using chained interrupts before commit ba714a9c
("pinctrl/amd: Use regular interrupt instead of chained")?
Signed-off-by: Daniel Kurtz <djkurtz@chromium.org>
Acked-by: Thomas Gleixner <tglx@linutronix.de>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

drivers/pinctrl/pinctrl-amd.c

@@ -552,7 +552,8 @@ static irqreturn_t amd_gpio_irq_handler(int irq, void *dev_id)
 		/* Each status bit covers four pins */
 		for (i = 0; i < 4; i++) {
 			regval = readl(regs + i);
-			if (!(regval & PIN_IRQ_PENDING))
+			if (!(regval & PIN_IRQ_PENDING) ||
+			    !(regval & BIT(INTERRUPT_MASK_OFF)))
 				continue;
 			irq = irq_find_mapping(gc->irq.domain, irqnr + i);
 			generic_handle_irq(irq);