imxfb: remove ifdefs

Here are some small fixes for the imxfb framebuffer driver:

 - remove ifndef for MX1FS2 platform which is not present in the kernel.
 - REV, CLS, PS and SPL_SPR are only needed with some sharp displays.
   Only setup the corresponding io pins when such a display is connected.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: Antonino Daplas <adaplas@gmail.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

drivers/video/imxfb.c

@@ -394,26 +394,18 @@ static void imxfb_setup_gpio(struct imxfb_info *fbi)
 
 	/* initialize GPIOs */
 	imx_gpio_mode(PD6_PF_LSCLK);
-	imx_gpio_mode(PD10_PF_SPL_SPR);
 	imx_gpio_mode(PD11_PF_CONTRAST);
 	imx_gpio_mode(PD14_PF_FLM_VSYNC);
 	imx_gpio_mode(PD13_PF_LP_HSYNC);
+	imx_gpio_mode(PD12_PF_ACD_OE);
+
+	/* These are only needed for Sharp HR TFT displays */
+	if (fbi->pcr & PCR_SHARP) {
 		imx_gpio_mode(PD7_PF_REV);
 		imx_gpio_mode(PD8_PF_CLS);
-
-#ifndef CONFIG_MACH_PIMX1
-	/* on PiMX1 used as buffers enable signal
-	 */
 		imx_gpio_mode(PD9_PF_PS);
-#endif
-
-#ifndef CONFIG_MACH_MX1FS2
-	/* on mx1fs2 this pin is used to (de)activate the display, so we need
-	 * it as a normal gpio
-	 */
-	imx_gpio_mode(PD12_PF_ACD_OE);
-#endif
-
+		imx_gpio_mode(PD10_PF_SPL_SPR);
+	}
 }
 
 #ifdef CONFIG_PM
@@ -499,6 +491,7 @@ static int __init imxfb_init_fbinfo(struct device *dev)
 	info->var.sync			= inf->sync;
 	info->var.grayscale		= inf->cmap_greyscale;
 	fbi->cmap_inverse		= inf->cmap_inverse;
+	fbi->cmap_static		= inf->cmap_static;
 	fbi->pcr			= inf->pcr;
 	fbi->lscr1			= inf->lscr1;
 	fbi->dmacr			= inf->dmacr;