Commit 9150b76a authored by Jesse Brandeburg's avatar Jesse Brandeburg Committed by Jeff Garzik

e1000: remove irq_sem

irq_sem was just a hack to prevent interrupts from being enabled
unexpectedly in deep call paths.  Simply finding those call paths and
fixing them by hand results in a driver that behaves as we expect and
doesn't need the atomic at all.
Signed-off-by: default avatarJesse Brandeburg <jesse.brandeburg@intel.com>
Signed-off-by: default avatarAuke Kok <auke-jan.h.kok@intel.com>
Signed-off-by: default avatarJeff Garzik <jeff@garzik.org>
parent 74ef9c39
......@@ -249,7 +249,6 @@ struct e1000_adapter {
#ifdef CONFIG_E1000_NAPI
spinlock_t tx_queue_lock;
#endif
atomic_t irq_sem;
unsigned int total_tx_bytes;
unsigned int total_tx_packets;
unsigned int total_rx_bytes;
......
......@@ -347,7 +347,6 @@ static void e1000_free_irq(struct e1000_adapter *adapter)
static void
e1000_irq_disable(struct e1000_adapter *adapter)
{
atomic_inc(&adapter->irq_sem);
E1000_WRITE_REG(&adapter->hw, IMC, ~0);
E1000_WRITE_FLUSH(&adapter->hw);
synchronize_irq(adapter->pdev->irq);
......@@ -361,10 +360,8 @@ e1000_irq_disable(struct e1000_adapter *adapter)
static void
e1000_irq_enable(struct e1000_adapter *adapter)
{
if (likely(atomic_dec_and_test(&adapter->irq_sem))) {
E1000_WRITE_REG(&adapter->hw, IMS, IMS_ENABLE_MASK);
E1000_WRITE_FLUSH(&adapter->hw);
}
}
static void
......@@ -638,7 +635,6 @@ e1000_down(struct e1000_adapter *adapter)
#ifdef CONFIG_E1000_NAPI
napi_disable(&adapter->napi);
atomic_set(&adapter->irq_sem, 0);
#endif
e1000_irq_disable(adapter);
......@@ -1396,7 +1392,6 @@ e1000_sw_init(struct e1000_adapter *adapter)
#endif
/* Explicitly disable IRQ since the NIC can be in any state. */
atomic_set(&adapter->irq_sem, 0);
e1000_irq_disable(adapter);
spin_lock_init(&adapter->stats_lock);
......@@ -3836,11 +3831,8 @@ e1000_intr_msi(int irq, void *data)
#endif
uint32_t icr = E1000_READ_REG(hw, ICR);
#ifdef CONFIG_E1000_NAPI
/* read ICR disables interrupts using IAM, so keep up with our
* enable/disable accounting */
atomic_inc(&adapter->irq_sem);
#endif
/* in NAPI mode read ICR disables interrupts using IAM */
if (icr & (E1000_ICR_RXSEQ | E1000_ICR_LSC)) {
hw->get_link_status = 1;
/* 80003ES2LAN workaround-- For packet buffer work-around on
......@@ -3910,12 +3902,8 @@ e1000_intr(int irq, void *data)
!(icr & E1000_ICR_INT_ASSERTED)))
return IRQ_NONE;
/* Interrupt Auto-Mask...upon reading ICR,
* interrupts are masked. No need for the
* IMC write, but it does mean we should
* account for it ASAP. */
if (likely(hw->mac_type >= e1000_82571))
atomic_inc(&adapter->irq_sem);
/* Interrupt Auto-Mask...upon reading ICR, interrupts are masked. No
* need for the IMC write */
#endif
if (unlikely(icr & (E1000_ICR_RXSEQ | E1000_ICR_LSC))) {
......@@ -3939,7 +3927,6 @@ e1000_intr(int irq, void *data)
#ifdef CONFIG_E1000_NAPI
if (unlikely(hw->mac_type < e1000_82571)) {
/* disable interrupts, without the synchronize_irq bit */
atomic_inc(&adapter->irq_sem);
E1000_WRITE_REG(hw, IMC, ~0);
E1000_WRITE_FLUSH(hw);
}
......@@ -3964,10 +3951,8 @@ e1000_intr(int irq, void *data)
* in dead lock. Writing IMC forces 82547 into
* de-assertion state.
*/
if (hw->mac_type == e1000_82547 || hw->mac_type == e1000_82547_rev_2) {
atomic_inc(&adapter->irq_sem);
if (hw->mac_type == e1000_82547 || hw->mac_type == e1000_82547_rev_2)
E1000_WRITE_REG(hw, IMC, ~0);
}
adapter->total_tx_bytes = 0;
adapter->total_rx_bytes = 0;
......@@ -5001,6 +4986,7 @@ e1000_vlan_rx_register(struct net_device *netdev, struct vlan_group *grp)
struct e1000_adapter *adapter = netdev_priv(netdev);
uint32_t ctrl, rctl;
if (!test_bit(__E1000_DOWN, &adapter->flags))
e1000_irq_disable(adapter);
adapter->vlgrp = grp;
......@@ -5038,6 +5024,7 @@ e1000_vlan_rx_register(struct net_device *netdev, struct vlan_group *grp)
}
}
if (!test_bit(__E1000_DOWN, &adapter->flags))
e1000_irq_enable(adapter);
}
......@@ -5064,8 +5051,10 @@ e1000_vlan_rx_kill_vid(struct net_device *netdev, uint16_t vid)
struct e1000_adapter *adapter = netdev_priv(netdev);
uint32_t vfta, index;
if (!test_bit(__E1000_DOWN, &adapter->flags))
e1000_irq_disable(adapter);
vlan_group_set_device(adapter->vlgrp, vid, NULL);
if (!test_bit(__E1000_DOWN, &adapter->flags))
e1000_irq_enable(adapter);
if ((adapter->hw.mng_cookie.status &
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment