Commit 94522bee authored by Sabrina Dubroca's avatar Sabrina Dubroca Committed by Greg Kroah-Hartman

net: ipv4: don't allow setting net.ipv4.route.min_pmtu below 68


[ Upstream commit c7272c2f ]

According to RFC 1191 sections 3 and 4, ICMP frag-needed messages
indicating an MTU below 68 should be rejected:

    A host MUST never reduce its estimate of the Path MTU below 68
    octets.

and (talking about ICMP frag-needed's Next-Hop MTU field):

    This field will never contain a value less than 68, since every
    router "must be able to forward a datagram of 68 octets without
    fragmentation".

Furthermore, by letting net.ipv4.route.min_pmtu be set to negative
values, we can end up with a very large PMTU when (-1) is cast into u32.

Let's also make ip_rt_min_pmtu a u32, since it's only ever compared to
unsigned ints.
Reported-by: default avatarJianlin Shi <jishi@redhat.com>
Signed-off-by: default avatarSabrina Dubroca <sd@queasysnail.net>
Reviewed-by: default avatarStefano Brivio <sbrivio@redhat.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent 65fe24fd
......@@ -126,10 +126,13 @@ static int ip_rt_redirect_silence __read_mostly = ((HZ / 50) << (9 + 1));
static int ip_rt_error_cost __read_mostly = HZ;
static int ip_rt_error_burst __read_mostly = 5 * HZ;
static int ip_rt_mtu_expires __read_mostly = 10 * 60 * HZ;
static int ip_rt_min_pmtu __read_mostly = 512 + 20 + 20;
static u32 ip_rt_min_pmtu __read_mostly = 512 + 20 + 20;
static int ip_rt_min_advmss __read_mostly = 256;
static int ip_rt_gc_timeout __read_mostly = RT_GC_TIMEOUT;
static int ip_min_valid_pmtu __read_mostly = IPV4_MIN_MTU;
/*
* Interface to generic destination cache.
*/
......@@ -2765,7 +2768,8 @@ static struct ctl_table ipv4_route_table[] = {
.data = &ip_rt_min_pmtu,
.maxlen = sizeof(int),
.mode = 0644,
.proc_handler = proc_dointvec,
.proc_handler = proc_dointvec_minmax,
.extra1 = &ip_min_valid_pmtu,
},
{
.procname = "min_adv_mss",
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment