iwlwifi: dvm: don't enable CTS to self

commit 43d826ca upstream.

We should always prefer to use full RTS protection. Using
CTS to self gives a meaningless improvement, but this flow
is much harder for the firmware which is likely to have
issues with it.
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
[bwh: Backported to 3.2:
 - Adjust filename
 - Condition for RXON_FLG_SELF_CTS_EN in iwlagn_commit_rxon() was different]
Signed-off-by: Ben Hutchings <ben@decadent.org.uk>

drivers/net/wireless/iwlwifi/iwl-agn-rxon.c

@@ -440,14 +440,6 @@ int iwlagn_commit_rxon(struct iwl_priv *priv, struct iwl_rxon_context *ctx)
 	/* always get timestamp with Rx frame */
 	ctx->staging.flags |= RXON_FLG_TSF2HOST_MSK;
 
-	/*
-	 * force CTS-to-self frames protection if RTS-CTS is not preferred
-	 * one aggregation protection method
-	 */
-	if (!(priv->cfg->ht_params &&
-	      priv->cfg->ht_params->use_rts_for_aggregation))
-		ctx->staging.flags |= RXON_FLG_SELF_CTS_EN;
-
 	if ((ctx->vif && ctx->vif->bss_conf.use_short_slot) ||
 	    !(ctx->staging.flags & RXON_FLG_BAND_24G_MSK))
 		ctx->staging.flags |= RXON_FLG_SHORT_SLOT_MSK;
@@ -880,11 +872,6 @@ void iwlagn_bss_info_changed(struct ieee80211_hw *hw,
 	else
 		ctx->staging.flags &= ~RXON_FLG_TGG_PROTECT_MSK;
 
-	if (bss_conf->use_cts_prot)
-		ctx->staging.flags |= RXON_FLG_SELF_CTS_EN;
-	else
-		ctx->staging.flags &= ~RXON_FLG_SELF_CTS_EN;
-
 	memcpy(ctx->staging.bssid_addr, bss_conf->bssid, ETH_ALEN);
 
 	if (vif->type == NL80211_IFTYPE_AP ||