Commit a292ca6e authored by Jeff Kirsher's avatar Jeff Kirsher Committed by Jeff Garzik

[PATCH] e1000: Added copy break code

Improves small packet performance with large amounts of reassembly being done in the stack.
Signed-off-by: default avatarJeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: default avatarJesse Brandeburg <jesse.brandeburg@intel.com>
Signed-off-by: default avatarJohn Ronciak <john.ronciak@intel.com>
Signed-off-by: default avatarJeff Garzik <jgarzik@pobox.com>
parent 240b1710
......@@ -420,7 +420,8 @@ e1000_up(struct e1000_adapter *adapter)
* next_to_use != next_to_clean */
for (i = 0; i < adapter->num_rx_queues; i++) {
struct e1000_rx_ring *ring = &adapter->rx_ring[i];
adapter->alloc_rx_buf(adapter, ring, E1000_DESC_UNUSED(ring));
adapter->alloc_rx_buf(adapter, ring,
E1000_DESC_UNUSED(ring));
}
#ifdef CONFIG_PCI_MSI
......@@ -3567,23 +3568,26 @@ e1000_clean_rx_irq(struct e1000_adapter *adapter,
uint32_t length;
uint8_t last_byte;
unsigned int i;
boolean_t cleaned = FALSE;
int cleaned_count = 0;
boolean_t cleaned = FALSE, multi_descriptor = FALSE;
i = rx_ring->next_to_clean;
rx_desc = E1000_RX_DESC(*rx_ring, i);
while(rx_desc->status & E1000_RXD_STAT_DD) {
buffer_info = &rx_ring->buffer_info[i];
u8 status;
#ifdef CONFIG_E1000_NAPI
if(*work_done >= work_to_do)
break;
(*work_done)++;
#endif
status = rx_desc->status;
cleaned = TRUE;
cleaned_count++;
pci_unmap_single(pdev, buffer_info->dma, buffer_info->length,
pci_unmap_single(pdev,
buffer_info->dma,
buffer_info->length,
PCI_DMA_FROMDEVICE);
skb = buffer_info->skb;
......@@ -3602,7 +3606,8 @@ e1000_clean_rx_irq(struct e1000_adapter *adapter,
if(TBI_ACCEPT(&adapter->hw, rx_desc->status,
rx_desc->errors, length, last_byte)) {
spin_lock_irqsave(&adapter->stats_lock, flags);
e1000_tbi_adjust_stats(&adapter->hw, &adapter->stats,
e1000_tbi_adjust_stats(&adapter->hw,
&adapter->stats,
length, skb->data);
spin_unlock_irqrestore(&adapter->stats_lock,
flags);
......@@ -3613,17 +3618,40 @@ e1000_clean_rx_irq(struct e1000_adapter *adapter,
}
}
/* Good Receive */
skb_put(skb, length - ETHERNET_FCS_SIZE);
/* code added for copybreak, this should improve
* performance for small packets with large amounts
* of reassembly being done in the stack */
#define E1000_CB_LENGTH 256
if ((length < E1000_CB_LENGTH) &&
!rx_ring->rx_skb_top &&
/* or maybe (status & E1000_RXD_STAT_EOP) && */
!multi_descriptor) {
struct sk_buff *new_skb =
dev_alloc_skb(length + NET_IP_ALIGN);
if (new_skb) {
skb_reserve(new_skb, NET_IP_ALIGN);
new_skb->dev = netdev;
memcpy(new_skb->data - NET_IP_ALIGN,
skb->data - NET_IP_ALIGN,
length + NET_IP_ALIGN);
/* save the skb in buffer_info as good */
buffer_info->skb = skb;
skb = new_skb;
skb_put(skb, length);
}
}
/* end copybreak code */
/* Receive Checksum Offload */
e1000_rx_checksum(adapter, (uint32_t)(rx_desc->status) |
e1000_rx_checksum(adapter,
(uint32_t)(status) |
((uint32_t)(rx_desc->errors) << 24),
rx_desc->csum, skb);
skb->protocol = eth_type_trans(skb, netdev);
#ifdef CONFIG_E1000_NAPI
if(unlikely(adapter->vlgrp &&
(rx_desc->status & E1000_RXD_STAT_VP))) {
(status & E1000_RXD_STAT_VP))) {
vlan_hwaccel_receive_skb(skb, adapter->vlgrp,
le16_to_cpu(rx_desc->special) &
E1000_RXD_SPC_VLAN_MASK);
......@@ -3830,8 +3858,14 @@ e1000_alloc_rx_buffers(struct e1000_adapter *adapter,
i = rx_ring->next_to_use;
buffer_info = &rx_ring->buffer_info[i];
while(!buffer_info->skb) {
while (cleaned_count--) {
if (!(skb = buffer_info->skb))
skb = dev_alloc_skb(bufsz);
else {
skb_trim(skb, 0);
goto map_skb;
}
if(unlikely(!skb)) {
/* Better luck next round */
......@@ -3872,6 +3906,7 @@ e1000_alloc_rx_buffers(struct e1000_adapter *adapter,
buffer_info->skb = skb;
buffer_info->length = adapter->rx_buffer_len;
map_skb:
buffer_info->dma = pci_map_single(pdev,
skb->data,
adapter->rx_buffer_len,
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment