Merge branch 'nfp-ksettings'
Jakub Kicinski says:
====================
nfp: ethtool link settings
This series adds support for getting and setting link settings
via the (moderately) new ethtool ksettings ops.
First patch introduces minimal speed and duplex reporting using
the information directly provided in PCI BAR0 memory.
Next few changes deal with the need to refresh port state read
from the service process and patch 6 finally uses that information
to provide link speed and duplex. Patches 7 and 8 add auto
negotiation and port type reporting.
Remaining changes provide the set support for speed and auto
negotiation. An upcoming series will also add port splitting
support via devlink.
Quite a bit of churn in this series is caused by the fact that
currently port speed and split changes will usually require a
reboot to take effect. Current service process code is not capable
of performing MAC reinitialization after chip has been passing
traffic. To make sure user is aware of this limitation we refuse
the configuration unless netdev is down, print warning to the logs
and if configuration was performed but did take effect we unregister
the netdev. Service process has a "reboot needed" sticky bit, so
reloading the driver will not bring the netdev back.
Note that there is a helper in patch 13 which is marked as
__always_inline, because the FIELD_* macros require the parameters
to be known at compilation time. I hope that is OK.
====================
Signed-off-by: David S. Miller <davem@davemloft.net>
Showing
Please register or sign in to comment