clk: sunxi-ng: r40: Add max. rate constraint to video PLLs

Video PLLs on R40 can be set to higher rate that it is actually
supported by HW.

Limit maximum rate to 1008 MHz. This is the maximum allowed rate by BSP
clock driver. Interestengly, user manual specifies maximum frequency to
be 600 MHz. Historically, this data was wrong in some user manuals for
other SoCs, so more faith is put in BSP clock driver.
Signed-off-by: Jernej Skrabec <jernej.skrabec@siol.net>
Signed-off-by: Maxime Ripard <maxime.ripard@bootlin.com>

drivers/clk/sunxi-ng/ccu-sun8i-r40.c

@@ -65,10 +65,10 @@ static SUNXI_CCU_NM_WITH_GATE_LOCK(pll_audio_base_clk, "pll-audio-base",
 				   BIT(28),	/* lock */
 				   CLK_SET_RATE_UNGATE);
 
-/* TODO: The result of N/M is required to be in [8, 25] range. */
-static SUNXI_CCU_NM_WITH_FRAC_GATE_LOCK_MIN(pll_video0_clk, "pll-video0",
+static SUNXI_CCU_NM_WITH_FRAC_GATE_LOCK_MIN_MAX(pll_video0_clk, "pll-video0",
 						"osc24M", 0x0010,
 						192000000,  /* Minimum rate */
+						1008000000, /* Maximum rate */
 						8, 7,       /* N */
 						0, 4,       /* M */
 						BIT(24),    /* frac enable */
@@ -152,10 +152,10 @@ static struct ccu_nk pll_periph1_clk = {
 	},
 };
 
-/* TODO: The result of N/M is required to be in [8, 25] range. */
-static SUNXI_CCU_NM_WITH_FRAC_GATE_LOCK_MIN(pll_video1_clk, "pll-video1",
+static SUNXI_CCU_NM_WITH_FRAC_GATE_LOCK_MIN_MAX(pll_video1_clk, "pll-video1",
 						"osc24M", 0x030,
 						192000000,  /* Minimum rate */
+						1008000000, /* Maximum rate */
 						8, 7,       /* N */
 						0, 4,       /* M */
 						BIT(24),    /* frac enable */